Top seal on Ford Vedette apron

Gasket to be glued to the top of the apron and allowing sealing with the cover (close to the windshield), length approximately 1.50m. Dimensions 10x20 mm

Windscreen seal Ford Vedette 1949/52 - with central pillar

Welded windscreen seal - with central upright - for Vedette 1949 to 52. Photo no contractual

Poissy badge for Simca Versailles rear trunk

Rear trunk badge. Can be assembled according to year on Versailles (Ford and Simca), Trianon, Versailles, Régence, Beaulieu, Chambord, Présidence, Marly 1 and 2.Only the red badge is delivered

jeu de 3 plots isolants pour cerclo volant Ford Vedette

Seals for deflector x2 Ford Vedette

Set of 2 deflector gaskets for Ford Vedette.Refabrication of original quality

Wiper - Stainless steel squeegee blades 205 mm x 2

Stainless steel wiper blades, squeegee type 20.5 cm . Mounts with the adjustable arms on sale HERE

MISTRAL engine nameplate

Windscreen wiper - repair kit for 5 mm axles

Shaft exit seal repair kit

Windscreen wiper - adjustable arms x 2 - 5 mm axle

Stainless steel wiper arm. Adjustable length from 20 to 30 cm. Tightening on 5 mm axle - Sold by 2

Gray gear lever knob for Ford Vedette dashboard

Gear shift knob, in Ford Vedette gray lacquered resin, with thread insert, as original

Gray needle button for Ford Vedette 53 and 54 dashboard

Resin button with Ford Vedette gray lacquered needle, with thread insert, as original.Sold individually. Please note this model with anti-rotation needle screw is intended for Fog and Heating controls (1953 to 54)

Boot handle sole kit - Ford Vedette 1949 -53 - sedan / coupe / cabriolet

Sole for Ford Vedette sedan, coupe, convertible. French manufacture by Techni-Tacot.Including:1 x sole for the trunk handle.

Clip-on exterior mirror - parabolic mirror

Clip-on mirror for mounting on door pillar. Supplied with 2 tightening screws + key. Parabolic mirror allowing a greater viewing angle than a flat mirror

bras x 2 inox fil axe 5 mm

Bras d'essuie glace inox. tige filaire - Serrage sur axe 5 mm. Se monte avec balais type raclette ou lame - Vendu par 2

Wiper - Stainless steel brushes x 2 - 285 mm

Stainless steel wiper blades. Length 285 mm. Sold by 2 Mounts with the adjustable arms on sale HERE

Essuie glace - Balais inox x 2 - 200 mm

Balais d'essuie glace inox. Longueur 200 mm. Vendu par 2