2-pin push button - 60 Amp - metal body - starter control

Top seal on Ford Vedette apron

Gasket to be glued to the top of the apron and allowing sealing with the cover (close to the windshield), length approximately 1.50m. Dimensions 10x20 mm

Wiper - Stainless steel squeegee blades 205 mm x 2

Stainless steel wiper blades, squeegee type 20.5 cm . Mounts with the adjustable arms on sale HERE

Windscreen wiper - adjustable arms x 2 - 5 mm axle

Stainless steel wiper arm. Adjustable length from 20 to 30 cm. Tightening on 5 mm axle - Sold by 2

bras x 2 inox fil axe 5 mm

Bras d'essuie glace inox. tige filaire - Serrage sur axe 5 mm. Se monte avec balais type raclette ou lame - Vendu par 2

jeu de 3 plots isolants pour cerclo volant Ford Vedette

MISTRAL engine nameplate

Wiper sole kit - Ford Vedette 1954

Kit semelle pour essuie glace Ford Vedette 1954 - Fabrication française soignée - Exclusivité techni-Tacot Comprend : 2 x semelles essuie glace

€11.90 TTC
(11,90 € HT)

Kit 2 x sole rear lights - Ford Vendome

Sole kit for Ford VENDOME. Made in France by Techni-Tacot.Including: 2 x bases for rear lights (above the stainless steel trim).Soles for the lower part (stainless steel trim) on sale here

€40.60 TTC
(40,60 € HT)

Windscreen wiper - Stainless steel brushes x2 - 220 mm

Stainless steel wiper blades. Length 220 mm. Sold by 2 Mounts with the adjustable arms on sale HERE

Seal 4 doors Ford Vedette Comete Vendome

Set of 4 door seals for Ford Vedette, Comète, Vendôme etc.

Volant Ford Vendome livré peint teinte au choix - refabrication - échange standard

Essuie glace - Balais inox x 2 - 200 mm

Balais d'essuie glace inox. Longueur 200 mm. Vendu par 2

Ford Vedette trunk seal

Trunk seal, length about 3 m

Windscreen wiper - Stainless steel brushes x 2 - 260 mm

Stainless steel wiper blades. Length 260 mm. Sold by 2 Mounts with the adjustable arms on sale HERE

Gray needle button for Ford Vedette 53 and 54 dashboard

Resin button with Ford Vedette gray lacquered needle, with thread insert, as original.Sold individually. Please note this model with anti-rotation needle screw is intended for Fog and Heating controls (1953 to 54)