Ford Vedette hood stopper

Front cover stopper - set of 4.

Seals for deflector x2 Ford Vedette

Set of 2 deflector gaskets for Ford Vedette.Refabrication of original quality

Gray needle button for Ford Vedette 53 and 54 dashboard

Resin button with Ford Vedette gray lacquered needle, with thread insert, as original.Sold individually. Please note this model with anti-rotation needle screw is intended for Fog and Heating controls (1953 to 54)

Boot handle sole kit - Ford Vedette 1949 -53 - sedan / coupe / cabriolet

Sole for Ford Vedette sedan, coupe, convertible. French manufacture by Techni-Tacot.Including:1 x sole for the trunk handle.

Wiper - Stainless steel brushes x 2 - 285 mm

Stainless steel wiper blades. Length 285 mm. Sold by 2 Mounts with the adjustable arms on sale HERE

Gray button for Ford Vedette dashboard

Ford Vedette gray lacquered resin knob, with thread insert, as original.4 to 6 pieces for Vedette from 1949 to 1952. Sold individually.Attention model with anti rotation needle screw for anti fog and heating (1953 to 54)

Ford Vedette side window or quarter window seal

Seal for quarter panel side window, welded, 2 per vehicle - Sold individually. Mounts on Ford Vedette, Abeille, Vendôme

Windscreen wiper - Stainless steel brushes x 2 - 260 mm

Stainless steel wiper blades. Length 260 mm. Sold by 2 Mounts with the adjustable arms on sale HERE

Wiper sole kit - Ford Vedette 1954

Kit semelle pour essuie glace Ford Vedette 1954 - Fabrication française soignée - Exclusivité techni-Tacot Comprend : 2 x semelles essuie glace

€11.90 TTC
(11,90 € HT)

Plate equipped for front left or right turn signal - Ford Vedette

Plate fitted for front left or right turn signal - Ford VedetteSupplied with the cork gasket, sockets with wires.Delivered without lamp.

Soundproofing with adhesive 1m2

Sound insulation in heavy plates. Allows you to lower the sound level. Self-adhesive (film to be removed before installation). Plate 200 x 500 mm. The package contains 10 plates, i.e. 1 m2 in total

Top seal on Ford Vedette apron

Gasket to be glued to the top of the apron and allowing sealing with the cover (close to the windshield), length approximately 1.50m. Dimensions 10x20 mm

2-pin push button - 60 Amp - metal body - starter control

Wiper - Stainless steel squeegee blades 205 mm x 2

Stainless steel wiper blades, squeegee type 20.5 cm . Mounts with the adjustable arms on sale HERE

Clip-on exterior mirror - parabolic mirror

Clip-on mirror for mounting on door pillar. Supplied with 2 tightening screws + key. Parabolic mirror allowing a greater viewing angle than a flat mirror

bras x 2 inox fil axe 5 mm

Bras d'essuie glace inox. tige filaire - Serrage sur axe 5 mm. Se monte avec balais type raclette ou lame - Vendu par 2