
Rear window seal Ford Vedette Coupe
Rear window seal, welded, for Coupé Vedette.
(114,30 € HT)
Wiper - Stainless steel squeegee blades 205 mm x 2
Stainless steel wiper blades, squeegee type 20.5 cm . Mounts with the adjustable arms on sale HERE
(13,00 € HT)
Front lights kit 2 x soles - Ford Vedette - 1949 to1952
Sole kit for Ford Vedette - 1949 to 1952. French manufacture by Techni-Tacot.Including:2 x soles for front light plate.
(35,70 € HT)
Windscreen wiper - Stainless steel brushes x 2 - 260 mm
Stainless steel wiper blades. Length 260 mm. Sold by 2 Mounts with the adjustable arms on sale HERE
(26,16 € HT)
Ford Vedette side window or quarter window seal
Seal for quarter panel side window, welded, 2 per vehicle - Sold individually. Mounts on Ford Vedette, Abeille, Vendôme
(52,00 € HT)
Kit of 2 x platinum rear light bases - Ford Vedette from 1949 to 1952
Sole kit for Ford Vedette from 1949 to 1952. Made in France by Techni-Tacot.Including:2 x soles for rear light plate.
(35,50 € HT)

2-pin push button - 60 Amp - metal body - starter control
(8,00 € HT)
Rear window seal Ford Vedette 1949-52
Rear window seal, welded, for Vedette Saloon 1949 to 52.
(118,65 € HT)
Boot handle sole kit - Ford Vedette 1949 -53 - sedan / coupe / cabriolet
Sole for Ford Vedette sedan, coupe, convertible. French manufacture by Techni-Tacot.Including:1 x sole for the trunk handle.
(26,68 € HT)
Seals for deflector x2 Ford Vedette
Set of 2 deflector gaskets for Ford Vedette.Refabrication of original quality
(332,00 € HT)
Gray needle button for Ford Vedette 53 and 54 dashboard
Resin button with Ford Vedette gray lacquered needle, with thread insert, as original.Sold individually. Please note this model with anti-rotation needle screw is intended for Fog and Heating controls (1953 to 54)
(20,92 € HT)
Windscreen seal Ford Vedette 1953/54
Welded windscreen seal - without central upright - for Vedette 1953 and 54. Non-contractual photo
(95,00 € HT)
Top seal on Ford Vedette apron
Gasket to be glued to the top of the apron and allowing sealing with the cover (close to the windshield), length approximately 1.50m. Dimensions 10x20 mm
(11,25 € HT)
Windscreen wiper - adjustable arms x 2 - 5 mm axle
Stainless steel wiper arm. Adjustable length from 20 to 30 cm. Tightening on 5 mm axle - Sold by 2
(30,00 € HT)
Viewed products
Segment set Ø 58.00 2x2x2x3.5 - Rosengart LR (set of 16)
Set of 16 segments (4 per piston) for LR2, LR4, LR4N2 engines and derivatives. Bore 57.50. Be careful in the event of an error on your part, these products cannot be taken back.- 3 x compression h 2mm- 1 x scraper h 3.5 mmContact us for other ...
(199,17 € HT)
Fuel pump - Horiz outlets - Citroen type Traction - U23 - HY
Fuel pump with primer, for Citroën Traction, delivered with gasket. Can also be mounted on U23 gasoline engine, HY, type H, and HZ equipped with the engine type Traction.
(30,00 € HT)
Master cylinder inside piston 20mm - with brake assist - Renault Saviem Sg2
Single circuit master cylinder for SG2 Renault or Saviem from 1970 to end of series. Current product of French manufacture.
(129,00 € HT)
