IGOL Rallye Gear axle transmission oil SAE 75 80 90 - GL4
Oil for gearbox and bridge for old mechanics. Type SAE 75 80 90 - GL4. 1L container.(Not suitable for Peugeot type screw axles)
€18.00 TTC
(15,00 € HT)
(15,00 € HT)
Peugeot D4 front hub kit
Attention: non-contractual photo. Kit for 1 front hub Peugeot D4B (check that your bearing dimensions correspond to those indicatedIncludes:1 x 55x100 bearing1 x 45x100 bearing2 x waterproof ringKit for one side
€89.90 TTC
(74,92 € HT)
(74,92 € HT)
Speedometer cable - Peugeot 203 - all models
Speedometer cable for Peugeot 203 convertible, sedan, commercial pick-up, all models (Non-contractual photo)
€54.00 TTC
(45,00 € HT)
(45,00 € HT)
Peugeot D3A Rear Hub Kit
Attention non-contractual photo. Kit for 1 rear hub - Peugeot D3A. Includes:2 bearings and a sealed ringKit for a left or right hub
€90.00 TTC
(75,00 € HT)
(75,00 € HT)
IGOL Oil for screw bridge and bronze crown - 2 liters - Peugeot 203 403 404
Special lubricant for rear axle and worm reducers. Has excellent pressure resistance properties, a very high viscosity index and good protection against oxidation and corrosion. Miscible with castor-based oils, and with extreme pressure oils. ...
€39.60 TTC
(33,00 € HT)
(33,00 € HT)
Peugeot D4 gearbox outlet seal
Sealing ring ("spinnaker") for Peugeot D4 gearbox outlet43x60 mm
€17.00 TTC
(14,17 € HT)
(14,17 € HT)
Viewed products
Mechanism clutch PKSC - Simca Chambord Versailles
Clutch mechanism reconditioned, in standard exchange mounted on Aquilon Simca V8 engineComplete disassembly, micro balling, surfacing and retaring of the pressure plate.(The sending is done after receipt of the used mechanism, not ...
€297.60 TTC
(248,00 € HT)
(248,00 € HT)
Brake master cylinder Ø 31.75 mm - Peugeot D3
Master cylinder complete with bellows: D 1'1 / 4 or 31.75 mm - inlet 3/4 - 16 f outlet 1/2 - 20fEntry in 18 mm. If the old model was 22mm, order the adapter here.Peugeot D3
€144.00 TTC
(120,00 € HT)
(120,00 € HT)
choke cable - Weber and Solex Citroen ID DS carburetor
choke cable - Weber and Solex Citroën ID DS carburetor. Length to cut depending on the model
€47.50 TTC
(39,58 € HT)
(39,58 € HT)
screen plate, front right skirt closure - Citroen DS until 1967 refabrication in sheet metal, original n °. DS85387A
mud flap behind front fender, under front pillar, with its stainless steel bracket, DS, left
€41.90 TTC
(34,92 € HT)
(34,92 € HT)
