Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
€6.36 TTC
(5,30 € HT)
(5,30 € HT)
Master cylinder inside pistons 53 mm - NO brake assist - Renault Saviem Sg2
Single circuit master cylinder fits to SG2 Renault or Saviem. NO break assist. Internal diameter (piston) 28.57 mm bettween fixing holes : 60 mm 2 exits 7/16 mm (mesure prise sur le raccord mâle venant de canalisation = 11.1 mm)
€160.80 TTC
(134,00 € HT)
(134,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
€13.80 TTC
(11,50 € HT)
(11,50 € HT)
Special brake grease tube - 5g
Tube of special braking grease (5gr), Lockheed DOT and silicone compatible, protects steel cylinder and piston parts, helps them slide, compatible with rubber parts.
€4.67 TTC
(3,89 € HT)
(3,89 € HT)
kit de reparation servofrein Hydrovac Ø 185 mm - Peugeot 404, Renault R8, Saviem
Hydrovac Ø 185 mm brake servo repair kit - Supplied with valve and residual valve.Peugeot 404, Renault R8, Saviem.
€190.00 TTC
(158,33 € HT)
(158,33 € HT)
Pipe Ø 8 mm from reservoir to master cylinder - 1 m
Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...
€50.40 TTC
(42,00 € HT)
(42,00 € HT)
male female brake hose - 11.1 mm - 7/16 - Renault SG2
Female male brake hose - 520 mm - Renault SG2Vehicle with single circuit braking circuit: 3 MF hoses are requiredVehicle with dual circuit braking system: 3 MF hoses + 2 FF hoses are required
€32.40 TTC
(27,00 € HT)
(27,00 € HT)
Contactor: copper seal kit for LONG stop contactor 022114
Set of 2 seals for STOP LONG contactor
€3.60 TTC
(3,00 € HT)
(3,00 € HT)
Brake line - from 100 to 150 cm
" Brake line remanufactured on request, only in copper diameter 6.35 mm. . Provide model (length and 2 original end caps) Shipment after receipt of your model. "
€62.04 TTC
(51,70 € HT)
(51,70 € HT)
LEFT 28.5mm rear brake cylinder - Renault SG2 - 1965 to the end
LEFT REAR brake cylinder for single or double circuit, from 1965 to end of series.
€127.50 TTC
(106,25 € HT)
(106,25 € HT)
Rubber teat end for brake reservoir
" Flexible connection for brake reservoir. (100% rubber compatible with lockheed and silicone) Must be fitted with the metal insert to prevent tearing and accidental emptying of the liquid reservoir. "
€11.40 TTC
(9,50 € HT)
(9,50 € HT)
