Pipe connection 1/2 20 UNF - 8 mm tube - special jar - 12.5 mm thread ext.
Rigid brake line nut. 1 / 2-20 UNF i.e. Ø 12.5 mm - drilling for 8 mm tube special brake reservoir
(5,15 € HT)
Front brake hose - Ford Vedette 1953 -54
FRONT brake hose Ford Vedette 1953 and 54, Vendôme, Comète, Monte Carlo Length 322 mm. NON-CONTRACTUAL photo
(26,00 € HT)
Contactor: copper seal kit for LONG stop contactor 022114
Set of 2 seals for STOP LONG contactor
(3,00 € HT)
Ford Vedette 31.7mm front cylinder required
Front wheel cylinder repair kit, with pistons and spring. (For one wheel)Diam 31.75 mm
(22,50 € HT)
Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,20 € HT)
Rear brake cylinder 25.4 mm - Ford Vedette
" Rear wheel cylinder repair kit, with pistons and spring. (For one wheel) Piston diameter = 25.4 mm "
(21,85 € HT)
Rear brake cylinder 25.4 mm - 1949-53 Ford Vedette
Rear wheel cylinder d 25.4mm, Ford Vedette (1949 to August 1953), Vendôme, Comète, Monté Carlo, Abeille. Right pipe entry. NON-CONTRACTUAL photo.
(42,00 € HT)
1/2 female 20 UNF connection on 8 mm tube (metal brake jar)
Metal tank foot nut (female 1/2 and d 8mm)
(9,25 € HT)
Brake line - from 0 to 50 cm
Brake line remanufactured on demand only in copper diameter 6.35 mm. Small model, length less than 50 cm. Provide model (length and 2 original tips) Shipping after receipt of your model.
(29,50 € HT)
Brake reservoir with rubber
Translucent tank, delivered with bracket; rubber plug and fitting.
(31,75 € HT)
Brake pipe - from 300 to 350 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(180,00 € HT)
Brake switch - stop - special silicone
Brake switch. STOP light function. 100% silicone liquid and LHM compatible1/2 - 20 thread / inch thread
(15,83 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Front brake cylinder 31.7 mm - Ford Vedette 54 and Abeille
Front wheel cylinder d 31.75 mm - Ford Commercial Vedette type Abeille and some Vedette 1954. (Check your model carefully before ordering).
(42,15 € HT)