Master cylinder Ford Vedette 25.4 mm - 1950-54 - Vendome Comete
" Ford Vedette d25.4 mm master cylinder - all models 1950 to 1954, Comète, Monte Carlo, Abeille, Vendôme. Attention special model for year 1949, also available in our shop. Delivered complete with bellows. "
€208.80 TTC
(174,00 € HT)
(174,00 € HT)
Brake line - from 100 to 150 cm
" Brake line remanufactured on request, only in copper diameter 6.35 mm. . Provide model (length and 2 original end caps) Shipment after receipt of your model. "
€62.04 TTC
(51,70 € HT)
(51,70 € HT)
Rear brake cylinder 25.4 mm - 1954 - inclined exit - Ford Vedette
Rear wheel cylinder d 25.4mm, inclined pipe inlet. Montage 1953 and 1954. NON-CONTRACTUAL photo.
€60.60 TTC
(50,50 € HT)
(50,50 € HT)
Rear brake cylinder 25.4 mm - Ford Vedette
" Rear wheel cylinder repair kit, with pistons and spring. (For one wheel) Piston diameter = 25.4 mm "
€26.22 TTC
(21,85 € HT)
(21,85 € HT)
Brake reservoir with nipple + contact
Brake fluid reservoir, translucent plastic.With plug, fixing bracket and electrical contact for minimum liquid level
€48.00 TTC
(40,00 € HT)
(40,00 € HT)
Front brake cylinder 31.7 mm - Ford Vedette 54 and Abeille
Front wheel cylinder d 31.75 mm - Ford Commercial Vedette type Abeille and some Vedette 1954. (Check your model carefully before ordering).
€53.40 TTC
(44,50 € HT)
(44,50 € HT)
Brake switch - stop - DOT 3 and 4
" Brake switch. STOP light function - compatible with synthetic liquid type" "lockheed" "Dot 3 and 4. If using 100% silicone liquid: Choose this other reference 1/2 - 20 thread / inch thread "
€19.55 TTC
(16,29 € HT)
(16,29 € HT)
Contactor: copper seal kit for LONG stop contactor 022114
Set of 2 seals for STOP LONG contactor
€3.60 TTC
(3,00 € HT)
(3,00 € HT)
Front brake hose - Ford Vedette 1953 -54
FRONT brake hose Ford Vedette 1953 and 54, Vendôme, Comète, Monte Carlo Length 322 mm. NON-CONTRACTUAL photo
€32.40 TTC
(27,00 € HT)
(27,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
€13.80 TTC
(11,50 € HT)
(11,50 € HT)
Front brake hose 380 mm - Ford Vedette 1949
Ford Vedette 1949 FRONT brake hose. Length 380 mm.
€30.00 TTC
(25,00 € HT)
(25,00 € HT)
Pipe Ø 8 mm from reservoir to master cylinder - 1 m
Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...
€50.40 TTC
(42,00 € HT)
(42,00 € HT)
Adapter connection 7/16 UNF female - 1/2 UNF male
Adapter connection 1/2 UNF male - 7/16 UNF female
€12.60 TTC
(10,50 € HT)
(10,50 € HT)
