
Ford Vedette 28.5mm front cylinder required
" Front wheel cylinder repair kit, with pistons and spring. (For one wheel) Ford Vedette fitting - Piston diameter = 28.57 mm "
(20,25 € HT)

Adapter connection 7/16 male - 3/8 female
Adaptateur freinage mâle 7/16 (envion 11mm) femelle 3/8
(19,00 € HT)
Contactor: copper seal kit for LONG stop contactor 022114
Set of 2 seals for STOP LONG contactor
(3,00 € HT)

Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,30 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Front brake hose 380 mm - Ford Vedette 1949
Ford Vedette 1949 FRONT brake hose. Length 380 mm.
(25,00 € HT)
Rear brake cylinder 25.4 mm - 1949-53 Ford Vedette
Rear wheel cylinder d 25.4mm, Ford Vedette (1949 to August 1953), Vendôme, Comète, Monté Carlo, Abeille. Right pipe entry. NON-CONTRACTUAL photo.
(43,25 € HT)

Master cylinder 25.4 mm - Ford Vedette 1949
Master cylinder, supplied complete with 25.4 mm bellows.Mounts on Ford Vedette 1949 (only)
(110,50 € HT)

Adapter connection 7/16 UNF female - 1/2 UNF male
Adapter connection 1/2 UNF male - 7/16 UNF female
(10,05 € HT)
Master cylinder Ford Vedette 25.4 mm - 1950-54 - Vendome Comete
" Ford Vedette d25.4 mm master cylinder - all models 1950 to 1954, Comète, Monte Carlo, Abeille, Vendôme. Attention special model for year 1949, also available in our shop. Delivered complete with bellows. "
(173,00 € HT)

Brake line - from 200 to 250 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(63,70 € HT)