
Contactor: copper seal kit for LONG stop contactor 022114
Set of 2 seals for STOP LONG contactor
(3,00 € HT)

Rear brake cylinder 25.4 mm - Ford Vedette
" Rear wheel cylinder repair kit, with pistons and spring. (For one wheel) Piston diameter = 25.4 mm "
(21,85 € HT)

Brake line - from 200 to 250 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(63,70 € HT)
copy of Set of 4 Ford Vedette rear jaws - 1954
Set of 4 rear brake shoes in standard exchange. (Send us your set before shipping the new one) High performance friction, applied by industrial gluing, no more rivets which damage the drums. Pickled and varnished jaws.
(132,00 € HT)

Raccord adaptateur 1/2 UNF mâle - 3/8 UNF femelle
Adaptateur freinage 1/2-20 UNF mâle par 3/8 24 filets femelle
(10,50 € HT)
Brake reservoir with nipple + contact
Brake fluid reservoir, translucent plastic.With plug, fixing bracket and electrical contact for minimum liquid level
(40,00 € HT)
Adapter fitting 7/16 Male - 7/16 female outgoing cone
Adapter fitting 7/16 Male - 7/16 female outgoing cone
(16,30 € HT)
Brake line - from 150 to 200 cm
Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.
(57,70 € HT)
Pipe connector 1/2 20 UNF - tube 6.35 mm - external thread 12.5 mm
Rigid brake line nut. 1 / 2-20 UNF or Ø 12.5 mm - drilling for 6.35 mm tube (1/4 p)
(4,50 € HT)
3/8 - 24 f copper pipe fitting
Rigid brake line nut. 3/8 x 24 threads / inch. Tube Ø 4.75 mm
(6,50 € HT)
Master cylinder 25.4 mm - Ford Vedette 1949
Master cylinder, supplied complete with 25.4 mm bellows.Mounts on Ford Vedette 1949 (only)
(110,50 € HT)

Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(9,00 € HT)