
Rear brake hose - 470mm - Ford Vedette 1949 a 54
REAR brake hose all Ford Vedette (1949 to 1954), Vendôme, Comète, Monté Carlo, Bee models. Long 470 mm.
(25,00 € HT)
Brake pipe - from 250 to 300 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(69,70 € HT)
Brake line - from 150 to 200 cm
Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.
(57,70 € HT)
Adapter fitting 3/8 UNF Male - 10x100 female
Adapter fitting 3/8 UNF Male - 10x100 female
(17,00 € HT)
Brake line - from 0 to 50 cm
Brake line remanufactured on demand only in copper diameter 6.35 mm. Small model, length less than 50 cm. Provide model (length and 2 original tips) Shipping after receipt of your model.
(39,70 € HT)
Contactor: copper seal kit for LONG stop contactor 022114
Set of 2 seals for STOP LONG contactor
(3,00 € HT)

Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,30 € HT)
Adapter connection 7/16 male - 11/16 female
Adaptateur freinage mâle 7/16 (envion 11mm) femelle 11/16 pour recevoir gros flexible (17mm mâle
(32,20 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Special brake grease tube - 5g
Tube of special braking grease (5gr), Lockheed DOT and silicone compatible, protects steel cylinder and piston parts, helps them slide, compatible with rubber parts.
(3,89 € HT)
Ford Vedette 28.5mm front cylinder required
" Front wheel cylinder repair kit, with pistons and spring. (For one wheel) Ford Vedette fitting - Piston diameter = 28.57 mm "
(20,25 € HT)

Front brake hose 380 mm - Ford Vedette 1949
Ford Vedette 1949 FRONT brake hose. Length 380 mm.
(25,00 € HT)
Front brake cylinder 31.7 mm - Ford Vedette 54 and Abeille
Front wheel cylinder d 31.75 mm - Ford Commercial Vedette type Abeille and some Vedette 1954. (Check your model carefully before ordering).
(44,00 € HT)

Canalisation Ø 8 mm bocal vers maitre cylindre - 1 m
Canalisation de frein refabriquée à la demande, uniquement en cuivre diamètre 8 mm
(42,00 € HT)