Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
€6.36 TTC
(5,30 € HT)
(5,30 € HT)
Rubber teat end for brake reservoir
" Flexible connection for brake reservoir. (100% rubber compatible with lockheed and silicone) Must be fitted with the metal insert to prevent tearing and accidental emptying of the liquid reservoir. "
€11.40 TTC
(9,50 € HT)
(9,50 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
€10.80 TTC
(9,00 € HT)
(9,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
€13.80 TTC
(11,50 € HT)
(11,50 € HT)
Front brake cylinder Ø25.4mm Simca Versailles
Front piston wheel cylinder 25.4mm
€92.40 TTC
(77,00 € HT)
(77,00 € HT)
3/8 - 24 f copper pipe fitting
Rigid brake line nut. 3/8 x 24 threads / inch. Tube Ø 4.75 mm
€7.80 TTC
(6,50 € HT)
(6,50 € HT)
Male thread brake reservoir
Brake fluid reservoir. Supplied with bracket, plug and 3/4 male connector 16 threads / p. External thread diameter = 18.5 mm. Delivered without caliper (fixing by the thread on the master cylinder). Lockeed and silicone compatible
€42.00 TTC
(35,00 € HT)
(35,00 € HT)
cable frein à main primaire - Simca Versailles chambord
€90.00 TTC
(75,00 € HT)
(75,00 € HT)
Simca Versailles 19mm rear brake cylinder kit
Complete repair kit for rear wheel cylinder in 19 mm. Supplied with pistons.
€53.16 TTC
(44,30 € HT)
(44,30 € HT)
