
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Brake switch - stop - special silicone
Brake switch. STOP light function. 100% silicone liquid and LHM compatible1/2 - 20 thread / inch thread
(16,29 € HT)
Special brake grease tube - 5g
Tube of special braking grease (5gr), Lockheed DOT and silicone compatible, protects steel cylinder and piston parts, helps them slide, compatible with rubber parts.
(3,89 € HT)
Flexible rear brake hose 349 mm Simca Versailles Chambord Ariane
Flexible rear brake hose 349 mm long. Male ext 9mm - female int Ø 8.3 mm. Don't forget to replace the copper gasket: click here a> (The vehicle has only 1 rear flexible) - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and ...
(27,00 € HT)
Male thread brake reservoir
Brake fluid reservoir. Supplied with bracket, plug and 3/4 male connector 16 threads / p. External thread diameter = 18.5 mm. Delivered without caliper (fixing by the thread on the master cylinder). Lockeed and silicone compatible
(35,00 € HT)
cable frein à main primaire - Simca Versailles chambord
(75,00 € HT)
Set of 4 relined rear brake shoes Simca Versailles
Set of 4 relined brake shoes (AR) for Simca V8 in standard exchange. Microblasting, varnish, industrial bonding of friction. Strong adhesion. Eliminates the problem of rivets which can damage the drums.Shipping upon receipt of worn parts.
(100,00 € HT)

Simca Versailles 19mm rear brake cylinder kit
Complete repair kit for rear wheel cylinder in 19 mm. Supplied with pistons.
(34,00 € HT)

3/8 - 24 f copper pipe fitting
Rigid brake line nut. 3/8 x 24 threads / inch. Tube Ø 4.75 mm
(6,50 € HT)
Brake reservoir with nipple + contact
Brake fluid reservoir, translucent plastic.With plug, fixing bracket and electrical contact for minimum liquid level
(40,00 € HT)
Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,30 € HT)
Viewed products
Front brake cylinder D Ø 28.5 mm - with bleeder Simca Ariane
Brake cylinder for front right wheel, equipped with a bleeder - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and Ariane 8 - Simca 1300 until September 1965Diameter 28.57 mm - Liquid inlet 3/8
(56,00 € HT)

1-wire fuel gauge - Peugeot 203
1-wire fuel gauge - Peugeot 203 Meticulous manufacturing
(38,00 € HT)
Heating valve with lever Ø 16 mm
Heating valve with lever Ø 16 mm. Synthetic material (no corrosion problem). Length connection end to other: 113.5 mm
(26,70 € HT)
Rear brake cylinder 34.9mm - SUMB Marmon
For Simca SUMB Marmon and other heavy-duty derivatives.Complete rear wheel cylinder 1'3 / 8 (34.93 mm).
(120,00 € HT)

Fuel pump WITHOUT lever Simca Ariane 4 Aronde P60
Fuel pump with primer. Supplied with base gasket.
(35,00 € HT)
cable frein à main primaire - Simca Versailles chambord
(75,00 € HT)
Front brake hose 550 mm - Simca 5
Front brake hose - Length 550 mm - 2 threaded ends Ø 17 mm.
(33,25 € HT)