Front brake cylinder 31.7 mm - Ford Vedette 54 and Abeille

Front wheel cylinder d 31.75 mm - Ford Commercial Vedette type Abeille and some Vedette 1954. (Check your model carefully before ordering).

€53.40 TTC
(44,50 € HT)

Brake line - from 100 to 150 cm

" Brake line remanufactured on request, only in copper diameter 6.35 mm. . Provide model (length and 2 original end caps) Shipment after receipt of your model. "

Rear brake cylinder 25.4 mm - Ford Vedette

" Rear wheel cylinder repair kit, with pistons and spring. (For one wheel) Piston diameter = 25.4 mm "

€26.22 TTC
(21,85 € HT)

Contactor: copper seal kit for LONG stop contactor 022114

Set of 2 seals for STOP LONG contactor

€3.60 TTC
(3,00 € HT)

Pipe connector 1/2 20 UNF - tube 6.35 mm - external thread 12.5 mm

Rigid brake line nut. 1 / 2-20 UNF or Ø 12.5 mm - drilling for 6.35 mm tube (1/4 p)

Adapter fitting 3/8 UNF Male - 10x100 female

Adapter fitting 3/8 UNF Male - 10x100 female

Adapter connection 7/16 UNF female - 1/2 UNF male

Adapter connection 1/2 UNF male - 7/16 UNF female

Brake switch - stop - special silicone

Brake switch. STOP light function. 100% silicone liquid and LHM compatible1/2 - 20 thread / inch thread

Brake pipe - from 250 to 300 cm

Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.

Jeu 4 machoires AVANT larg 65mm - Ford Comete

€192.00 TTC
(160,00 € HT)

Front wheel 28.6 mm blind cylinder rebuild kit - Ford Vedette

Repair kit for front wheel cylinder 28.5 mm. Supplied with piston. Ford Vedette 1953 (4 per vehicle are needed)

€24.42 TTC
(20,35 € HT)

Pipe Ø 8 mm from reservoir to master cylinder - 1 m

Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...

Copper pipe fitting 7/16 - ext thread 11mm

Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm

Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone

Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone

Copper gasket 12 x 18 mm

Copper gasket 12 x18 x  1.5mm thick

€1.80 TTC
(1,50 € HT)

Dot 4 brake fluid

Dot 4 brake fluid - 500ml can. Non contractual photo