Repair kit for 2 front shocks - 38 mm - Peugeot 203 or 403 - before 1954

Repair kit for Peugeot 203 and 403 front shock absorbers. The kit allows you to renovate 2 FRONT shock absorbers, including:- 4 sealed bearings- 4 sealing rings- 2 silent blocks of arm length 38 mm (there is a version in 44 mm)- 1 oil can for ...

Electric Easy Drive power steering kit

Gear rack Peugeot 203 403

Bellows for rack. Sold individually

Peugeot 203 Utility rear hub kit

Kit for 1 rear hub Peugeot 203 including 1 bearings and a sealing ring - brand bearing (no remanufacturing unknown). Sold individually. (2 kits are needed to equip a car)  

Speedometer cable - Peugeot 203 - all models

Speedometer cable for Peugeot 203 convertible, sedan, commercial pick-up, all models (Non-contractual photo)

bush side axle fits to rear axle half shaft 32mm - Peugeot 203

Sealing ring for 1/2 wheel shaft. Replaces the bakelite rings located in the rear axle trumpets on Peugeot 203.Used to stop the oil from the axle towards the rear hubs. (2 per car) Sold individually  

Steering ball joint Peugeot 203 403

Repair kit for steering ball joint

Peugeot 203 front hub kit - 1st generation

Kit for 1 front hub Peugeot 203 - 1st generation including 2 well-known brand bearingsDim 20 x 52 width 15 mmDim 25 x 62 width 17 mmWarning: check that these dimensions correspond to your vehicle before ordering - Kit for a single wheel.

Front shock absorber bush - 44 mm - After 54 - Peugeot 203-403

Front shock absorber block 2nd generation model length 44 mm Ø 12 int and 25 ext

Set of 4 rubber rings for Peugeot 203 pivots

Set of 4 rubber rings for Peugeot 203 pivots.Approximate dimensions:- 7 x 33 x 41 mm- 7.5 x 25 x 34 mmAllows to equip the 2 steering pivots.

Silent block eyelet Peugeot 203-403

Silent block fixed to the axle for connection with shock absorber rod.int 12 mm, ext 30 mm

IGOL Rallye Gear axle transmission oil SAE 75 80 90 - GL4

Oil for gearbox and bridge for old mechanics. Type SAE 75 80 90 - GL4. 1L container.(Not suitable for Peugeot type screw axles)

Repair kit 2 front shocks - 44mm - Peugeot 203 or 403

" Repair kit for Peugeot 203 and 403 front shock absorbers. The kit allows you to renovate 2 FRONT shock absorbers, including: - 4 sealed bearings - 4 sealing rings - 2 silent blocks of arm length 44 mm (there is a version in 38 mm) - 1 can of ...

Butée conique caoutchouc Peugeot 203-403

Conical rubber front bottoming stop - Peugeot 203 and 403Ø46 - height 60 mm

Bearing 35 72 17 gearbox groove C2 for Peugeot 203

35x72x17 bearing with locking groove, special Peugeot 203 C2 gearbox

Hub Cap O-Ring - 203-403-404-D3-D4

hub cap o-ringØ 48x56x4mm