Peugeot 203 403 shock absorber oil can

Oil can for Peugeot 203 and 403 shock absorbers (1L)

Hub Cap O-Ring - 203-403-404-D3-D4

hub cap o-ringØ 48x56x4mm

aluminum gasket for shock absorber cap - Peugeot 203 or 403

aluminum gasket for shock absorber cap - Peugeot 203 or 403Sold individually

bush side axle fits to rear axle half shaft 35 mm - Peugeot 203

Sealing ring for 1/2 wheel shaft. Replaces the bakelite rings located in the rear axle trumpets on Peugeot 203.Used to stop the oil from the axle towards the rear hubs. (2 per car) Sold individually  

Set of 4 rubber rings for Peugeot 203 pivots

Set of 4 rubber rings for Peugeot 203 pivots.Approximate dimensions:- 7 x 33 x 41 mm- 7.5 x 25 x 34 mmAllows to equip the 2 steering pivots.

Speedometer cable - Peugeot 203 - all models

Speedometer cable for Peugeot 203 convertible, sedan, commercial pick-up, all models (Non-contractual photo)

Flector Peugeot 203 403

Flector de direction

Steering block Peugeot 203-403

Silent block at the end of the rack.int 12 mm, ext 30 mm

Steering ball joint Peugeot 203 403

Repair kit for steering ball joint

Universal bearing grease

For greasing bearings - Water resistant

Silent block front suspension blades - Peugeot 203-403 - 1954 at the end

Silent block for FRONT suspension with 7 blades of 70mm and for utilities U8 with suspension with 9 bladesFrom 1954 to end of series12x25x50x54

Gear rack Peugeot 203 403

Bellows for rack. Sold individually

Peugeot 203 Utility rear hub kit

Kit for 1 rear hub Peugeot 203 including 1 bearings and a sealing ring - brand bearing (no remanufacturing unknown). Sold individually. (2 kits are needed to equip a car)  

IGOL Rallye Gear axle transmission oil SAE 75 80 90 - GL4

Oil for gearbox and bridge for old mechanics. Type SAE 75 80 90 - GL4. 1L container.(Not suitable for Peugeot type screw axles)

bague etanche pour pont U8 37x61- peugeot 203 utilitaire

Peugeot 203 front hub kit - 2nd generation

Kit for 1 front hub Peugeot 203 - 2nd generation including 2 bearings and a sealing ring - brand bearings (no remanufacturing unknown)Dim 20 x 52 width 15 mmDim 30 x 62 width 16 mmWarning: check that these dimensions correspond to your generation ...