Copper gasket 11.50 x 20

Copper gasket 20x11.50 mm thickness 1mm

€1.80 TTC
(1,50 € HT)

Master cylinder 22mm Simca Versailles Chambord

Complete master cylinder D 22 mm. For Simca V8 (Versailles, Chambord, Marly, Ariane 4 and Ariane 8 etc.) before April 1960. Output 1/2 20f / p

€91.20 TTC
(76,00 € HT)

Flexible rear brake hose 349 mm Simca Versailles Chambord Ariane

Flexible rear brake hose 349 mm long. Male ext 9mm - female int Ø 8.3 mm. Don't forget to replace the copper gasket: click here a> (The vehicle has only 1 rear flexible) - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and ...

Copper gasket 10 x 18

Copper gasket 18x10 mm thickness 1mm

€2.16 TTC
(1,80 € HT)

Rear brake cylinder L or R (incoming) 23.8 mm - Simca Chambord

Rear wheel cylinder. Left or Right mounting - Simca Beaulieu Chambord Presidence Marly Ariane 4 and Ariane 8. Diameter: 23.81 mm - Version with cone entering the bottom of the thread at the liquid inlet. See detail photo.

€61.50 TTC
(51,25 € HT)

Front brake cylinder Ø 28.5 mm - set of 4 - Simca Chambord

Set of 4 front brake cylinders. -Simca Beaulieu, Chambord, Présidence as well as Ariane 4 and Ariane 8 - Simca 1300 until September 1965.Comprises: one cylinder with left bleed, one with right bleed and two cylinders without bleed.Diameter 28.57 ...

€259.20 TTC
(216,00 € HT)

Front brake cylinder repair kit Ø 28.5 mm - Simca Chambord

Required overhaul for 1 front wheel cylinder. Diameter 28.57 mm

€24.42 TTC
(20,35 € HT)

Copper pipe fitting 7/16 - ext thread 11mm

Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm

cable frein à main primaire - Simca Versailles chambord

Copper gasket 12 x 18 mm

Copper gasket 12 x18 x  1.5mm thick

€1.80 TTC
(1,50 € HT)

Copper seal 10.2 x 13.5

Copper gasket 10.2 x 13.5 mm thickness 1mm

€1.80 TTC
(1,50 € HT)

Male connector 12x100 on 6.35 mm pipe

Male connector 12x100 on 6.35 mm pipe

cable frein à main secondaire - Simca Versailles chambord (sauf Rushmatic)

Special brake grease tube - Plastilub ATE - 75 ml

Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!

Front brake cylinder L Ø 28.5 mm - with bleeder - Simca Chambord

" Left front wheel brake cylinder, equipped with a bleeder - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and Ariane 8 - Simca 1300 until sept. 1965 Diameter 28.57 mm "

€67.20 TTC
(56,00 € HT)

Copper gasket 13.1 x 17

Copper gasket 13.1 x 17 mm thickness 1mm

€1.80 TTC
(1,50 € HT)