
Rear brake cylinder rebuild kit 19mm - Simca Chambord
" Complete overhaul kit for a rear wheel cylinder. Diameter: 23.81 mm "
(20,00 € HT)

Special brake grease tube - 5g
Tube of special braking grease (5gr), Lockheed DOT and silicone compatible, protects steel cylinder and piston parts, helps them slide, compatible with rubber parts.
(3,89 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(9,00 € HT)
Silicone brake fluid DOT 5 - 1L
" DOT 5 100% silicone brake fluid - 1L can - Purple color - Do not mix with other types of brake fluids. The installation must be rinsed before changing the type of liquid. Photo not contractual. "
(44,96 € HT)
Flexible rear brake hose 349 mm Simca Versailles Chambord Ariane
Flexible rear brake hose 349 mm long. Male ext 9mm - female int Ø 8.3 mm. Don't forget to replace the copper gasket: click here a> (The vehicle has only 1 rear flexible) - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and ...
(27,00 € HT)
Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,30 € HT)
Brake reservoir with nipple + contact
Brake fluid reservoir, translucent plastic.With plug, fixing bracket and electrical contact for minimum liquid level
(40,00 € HT)
Front brake hose 349 mm Simca Versailles Chambord Ariane
Front brake hose 349 mm long. (The vehicle has 2 front hoses) Ø 3/8 For Simca V8, Versailles, Regence, Chambord, Présidence, Trianon, Marly, Ariane 4 and Ariane 8, etc.
(27,00 € HT)
Front brake cylinder D Ø 28.5 mm - with Simca Chambord bleeder
" Front right wheel brake cylinder, equipped with a bleeder - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and Ariane 8 - Simca 1300 until September 1965 Diameter 28.57 mm "
(56,00 € HT)

Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)