
Kit of 12V electric fuel pump
" 12V electric fuel pump. Connects in series with the original fuel line. Keeps the hand pump. Avoids having to lift the hood to turn up gasoline before starting. To be powered through a push button for occasional operation. Low pressure, no need ...
(80,00 € HT)
12v to 6v regulator for temperature, pressure, fuel gauge
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
(30,00 € HT)
copy of Bearing 6203 - 17x40x12
Bearing - 17x40x12 waterproof (often used on dynamo, water pump, flywheel center, etc.). Check with the dimensions of your bearing.
(9,00 € HT)
set of 2 spinnaker rings 32x55x10
(38,00 € HT)
Segments set - 64 mm - 2x2x2x3.5x3.5 - Peugeot 201
Set of 20 segments (5 per piston).Composition:Cylinder bore 64 mm12 waterproof segments, 2 mm high8 scraper segment height 3.5 mmOther dimensions available, contact us.
(107,00 € HT)
coupelle soupape Perfo
(5,00 € HT)
Standard 6V coil ignition
Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.
(36,00 € HT)
Ignition coil 6V - High Performance
Bosch, NGK or Béru High Performance type ignition coil, guaranteed for use with:- 6 V platinum-plated screw igniter (breakers),- electronic ignition type 123 ignition,- platinum screw igniter + electronic amplification module
(68,00 € HT)
Shaft 8.5 mm Ø repair - repair Solex 32 PBIC carburettor or similar
Shaft dimension repair 8.5 mm with butterfly for repair carburettor Solex 32 PBIC or similarOverall length 91.5 mm
(22,00 € HT)
Head gasket (2-stage engine) - Peugeot 201
Head gasket (2-stage engine) - Peugeot 201
(133,33 € HT)
collecteur 15-6 neuf
(723,00 € HT)
Aviation collex type paste gasket for cylinder head - 450ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
(35,00 € HT)
Carter Distri occasion rénové AQUI
(241,67 € HT)
pair of .020 bearings in after-sales service
(57,00 € HT)