Head gasket 2 mm solid copper Ford Vedette

Solid copper cylinder head gasket. 2mm thickness. Used with planed cylinder head. Tightening to 5m.kg. Mandatory installation with aerosol sealant, available here a>. Measured cylinder head thickness Head gasket type 37.3 mm ...

Ford 53 and 54 crankshaft bearing screws

Set of bearing screws for V8 Ford Vedette model 1953 and 1954

Ford Vedette air filter + breather sticker

" Sticker for air filter and breather cap. Mounts on Ford V8 Vedette, Vendôme, Cometer, Monte Carlo etc. Sticker "

Support de manomètre

Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.

Ford Vedette gearbox inlet seal ring

Sealing ring (oil seal) placed at the Ford Vedette gearbox outlet.35 x 51

Standard 6V coil ignition

Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.

Ford Vedette Stromberg 22.2 Carburetor Kit

Overhaul kit for Stromberg 22.2 (2x30 mm) carburetor. Delivered with complete recovery pump. Fitting on Ford Vedette.

Reinforced collar for exhaust - Ø 52-55 mm

Reinforced collar for exhaust - Ø 52.55 mmRobust French manufacturing

Pinion oil pump mounted on axis - Ford Vedette

Replacement gear for oil pump - V8 Ford Vedette.Delivered riveted with new axle. (Advantageously replaces the celoron one that has become fragile over time)Attention for the V8 Simca 13 hp 2350 cm3, choose the reference "Simca oil pump pinion" on ...

€270.20 TTC
(270,20 € HT)

Battery switch - safety

Battery isolator - used to electrically isolate the battery. To be placed on a terminal of the battery.

Ignition coil 12v VALEO

Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)

Ford Vedette bearings - 030 - 52.54 mm

" Bearing set for Ford Vedette engine 1949 -54. (1 rear flange bearing + 2 front and central single bearings) Dimension: .030 US (0.75 mm) "

Set of 2 Ford Vedette front engine mounts

" Set of 2 front supports for V8 Ford Vedette. Fixing center distance to be slightly modified. "

Ignition capacitor 6, 12 and 24V

6.12V and 24V compatible ignition capacitor.

Exhaust manifold paint - 250 ml

€48.00 TTC
(40,00 € HT)

Oil pressure contact mano - Ford Vedette 1949 - 54

oil pressure switch for Ford Vedette engine from 1949 to 1954 - Thread M 10x100