Exhaust collar flange Ø 45mm

Flange for exhaust connection (clamp with caliper) Ø 45 mm

demi lune occasion

12v to 6v regulator for temperature, pressure, fuel gauge

This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...

copy of Bearing 6203 - 17x40x12

Bearing - 17x40x12 waterproof (often used on dynamo, water pump, flywheel center, etc.). Check with the dimensions of your bearing.

8 x sealed segments 53.50 mm thick 2mm + 4 x scraper segments without spring in 54.00 3mm thick

8 x sealed segments 53.50 mm thick 2mm + 4 x scraper segments without spring in 54.00 3mm thick

Copper cylinder head gasket - Citroen trefle 5HP

Copper cylinder head gasket - Citroen trefle

Head gasket (2-stage engine) - Peugeot 201

Head gasket (2-stage engine) - Peugeot 201

Jeu segments Ø 86 mm 3.5x3x3x4.5 - Renault moteur 460

Sleeve Ø 48 mm ECHAP with inner blade

Copper cylinder head gasket - FIAT BALILLA 508

Copper cylinder head gasket - FIAT BALILLA 508

Segments set - 64 mm - 2x2x2x3.5x3.5 - Peugeot 201

Set of 20 segments (5 per piston).Composition:Cylinder bore 64 mm12 waterproof segments, 2 mm high8 scraper segment height 3.5 mmOther dimensions available, contact us.

joint inter collecteur ech/adm - 15-6

Carter Distri occasion rénové AQUI

Shaft 8.5 mm Ø repair - repair Solex 32 PBIC carburettor or similar

Shaft dimension repair 8.5 mm with butterfly for repair carburettor Solex 32 PBIC or similarOverall length 91.5 mm

Segments set - 64 mm - 2.5x2.5x2.5x3.5x3.5 - Peugeot 201

Set of 20 segments (5 per piston).Composition:Cylinder bore 64 mm12 waterproof segments, 2.5 mm high8 scraper segment height 3.5 mmOther dimensions available, contact us.

copy of Set of 2 multiplier gears "+ 15%" for Citroen HY gearbox

Set of cut-rectified multiplier gears. Allows to lengthen by about 15% all the ratios of the HY gasoline engine gearbox (ONLY on gearboxes equipped with a 21 and 26 tooth set). Concerns the 2 gears at the back of the box.Warning: any change in ...