Spark plug Motorcraft AG 1 x 4

4 x Motocraft AG 1 spark plugs - Ami Super - GS - Simca 1000 See list on photos

joint de culasse rosalie 8cv

Disc clutch Peugeot 202

Reconditioned clutch disc, in standard exchange for Peugeot 202. Complete disassembly, micro balling and painting. (The sending is done after receipt of the used mechanism, not destroyed) (Depending on the year, non-contractual photo)

€120.00 TTC
(100,00 € HT)

Modification usinage 4 x pistons Ø 85.00

Ignition head Ducellier 65 mm

Head for Ducellier distributor: Interlocking inside the head = 65 mm, outside about 72 mm.To be assembled with breakers 1 237 013 808, and ducellier finger.

Exhaust manifold paint - 250 ml

€48.00 TTC
(40,00 € HT)

160 mm float fuel gauge - 6V

" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "

collecteur 15-6 neuf

vacuum capsule for ducellier igniter

Electronic ignition amplifier assistance module - 12V negative to earth

Electronic ignition assistance module. Allows for more energetic spark plug ignition, improved starting, smoother pick-up, helps reduce fuel consumption and consequently pollution.The breakers (platinum-plated screws) are left in place - the ...

set of 2 spinnaker rings 32x55x10

Joint culasse vendu seul - Renault R8 Gordini 1296 cm3

Exhaust suspension ring 63x96 width 27 mm - Peugeot 203

Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm

Head gasket (2-stage engine) - Peugeot 201

Head gasket (2-stage engine) - Peugeot 201

Ignition coil 12v VALEO

Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)

copy of Bearing 6203 - 17x40x12

Bearing - 17x40x12 waterproof (often used on dynamo, water pump, flywheel center, etc.). Check with the dimensions of your bearing.