Renault Goelette Fregate bearings, dimension 0.25 - 55.75 mm
Set of 6 bearing shells, dimension 0.25, 55.75 mm trunnion, Renault type 668 - 671 engine (Colorale, Goélette, R2087, Frégate, etc.)668 and 671 engine and Super Etendard 817 - 2.6 L
€466.20 TTC
(388,50 € HT)
(388,50 € HT)
Renault engine connecting rod bearings Fregate dimension 0.50 - 51.50 mm
Set of 8 connecting rod bearings dimension 0.50 crankpin Ø 51.50 mm - Frigate engine 668 - 11cv - 2L
€282.00 TTC
(235,00 € HT)
(235,00 € HT)
Ignition silicone harness for Renault Frégate type engine
Ignition harness (5 wires) for Renault type 668 or 671 engine (Colorale, Goélette, R2087, Frégate, etc). Highly recommended with electronic ignition. Wire with red silicone insulator, works with platinum screws or electronic ignition, current ...
€50.40 TTC
(42,00 € HT)
(42,00 € HT)
Cartridge for oil filter renault fregate prairie etc.
Cartridge for Renault Frégate, Prairie, Colorale, Goélette, Transfluide oil filter.(for engines fitted with a filter holder). Central Ø = 8mm approx - Height = 123 mm - Ø 65 mm
€15.00 TTC
(12,50 € HT)
(12,50 € HT)
Engine gaskets set with cylinder head gasket - Renault 668/671
Engine gaskets kit (top and bottom) Renault type 668 and 671 (11 and 12hp) (Colorale, Goélette, R2087, Frégate, etc). Includes gaskets for:- cylinder head, rocker cover, 8x valve stem, 2 on central oil tee, tappet housing, 2 x ADM / ECH,- water ...
€179.00 TTC
(149,17 € HT)
(149,17 € HT)
270mm float fuel gauge - 6V
" Float fuel gauge. Adaptable model. Arm length approx. 270 mm. External plate diameter 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance about 110 ohms and vehicle in 6V. "
€49.90 TTC
(41,58 € HT)
(41,58 € HT)
Piston-liners kit - Base Ø 93 - Renault 671 Prairie Colorale, Goelette R2087
" Kit 4 liners / pistons for Renault type 671 engine (Colorale, Goélette, R2087, Frégate, etc) Etendard engine, 12hp, 2150 cm3. Bore 88 base 93mm. Composed of 4 pistons with pin segments and circlips, 4 barrels. New original Renault stock. "
€576.00 TTC
(576,00 € HT)
(576,00 € HT)
Standard 6V coil ignition
Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.
€54.00 TTC
(45,00 € HT)
(45,00 € HT)
Support de manomètre
Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.
€12.00 TTC
(10,00 € HT)
(10,00 € HT)
Electronic regulator for 6 V dynamo (negative to ground)
Electronic regulator for 6V positive-ground dynamo - Ford Vedette - Simca Versailles (standard exchange)For positive-ground dynamos.Charge stabilization at 7.4 V. Brighter lighting, better battery charge quality, improved ignition voltage.
€208.00 TTC
(208,00 € HT)
(208,00 € HT)
603 cylinder head gasket Renault side engine 85
Head gasket - Renault lateral 85 - 603. 195 x 480 mmPlease note that there are several versions depending on the type of 603. Check the shape with the photo and in particular the igniter passage hole located at the edge of half of the long length.
€162.00 TTC
(135,00 € HT)
(135,00 € HT)
Segment set Standard 88mm 2x2x4.5x4.5 Renault Fregate
Set of 16 segments for 4 eyebolts dimension 88 mm - 668 or 671 Renault petrol engine.composition per piston:2 x compression in 2 mm2 x scraper in 4.5 mmPossibility of ordering in 85 mm (call us)
€149.82 TTC
(124,85 € HT)
(124,85 € HT)
Renault Prairie Colorale transfer case bearing kit
Bearing kit for the reconditioning of Renault 4x4 Prairie Colorale, R2087 and derivative 4WD transfer boxes.The kit contains 6 bearings for the 3 internal shafts. It is important to replace the 3 waterproof rings sold on this store.(No ...
€384.30 TTC
(320,25 € HT)
(320,25 € HT)
Gasket x 2 on rocker arm Renault fregate Goelette Prairie
2 seals for rocker shaft. Mounts for Renault gasoline engine 668, 671, 817, mounted on Frégate, Prairie, R2087, SG2, Goélette and derivatives.
€19.20 TTC
(16,00 € HT)
(16,00 € HT)
Reinforced collar for exhaust - Ø 44-47 mm
Reinforced collar for exhaust - Ø 44-47 mmRobust French manufacturing
€5.80 TTC
(4,83 € HT)
(4,83 € HT)
Fuel gauge - replacement float
Float in synthetic material resistant to current fuels. Used to replace the cork floats on the fuel gauge Length: 1.40" Diameter: 1.14"
€17.72 TTC
(17,72 € HT)
(17,72 € HT)
