
Shaft 8.5 mm Ø repair - repair Solex 32 PBIC carburettor or similar
Shaft dimension repair 8.5 mm with butterfly for repair carburettor Solex 32 PBIC or similarOverall length 91.5 mm
(22,00 € HT)
Citroen HY U23 Traction timing chain
Distribution chain. Non contractual photo.
(28,33 € HT)
Cartridge air filter - Citroen HY before 1963
Cartridge air filter - Citroen HY before 1963Dimensions on the photo
(21,58 € HT)
Stainless steel cylinder head tube Citroen Traction - HY - U23
Water tube for cooling cast iron cylinder head. Citroen Traction, HY, U23 and derivativesStainless steel construction
(21,00 € HT)
Ignition harness - 1963 and up - Citroen HY engine H72 or H78 (ID19)
Ignition harness (5 wires) for Citroën HY engine H72 or H78, DS 19 ID 19. Highly recommended with electronic ignition.Wire with red insulation, works with platinum screws or electronic ignition, current manufacture (not from old stocks).
(29,00 € HT)
Exhaust support strap reinforces 90 mm
Suspension strap for exhaust. Robust construction, reinforced rubber, metal eyelets.92 mm center distance for M8 mm screws.
(13,48 € HT)
4 intake valves 42 x 107.7 x 9 mm - Citroen HY engine ID19
4 intake valves 42 x 107.7 x 9 mm - Citroen HY from 1963 and Citroen DS and ID until 1965
(68,03 € HT)
Fuel needle - Solex 32 PBIC carburettor or similar
Fuel needle - Solex 32 PBIC carburettor or similar
(9,90 € HT)
Dark green engine paint RAL 6005 - 500 ml
Dark green engine paint RAL 6005 -Pot of 500 mlSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated ...
(34,00 € HT)

Connecting rod bearings (set) 47.00 mm dimension 1.00 - Citroen Traction 11D - HY -U23
Conrod bearing set 47.00 mm - dimension 1.00 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
(85,00 € HT)
Engine paint black RAL 9005 - 500 ml
Black paint - 500 ml jarSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim 4090), ...
(34,00 € HT)

Support de manomètre
Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.
(7,94 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
(163,07 € HT)