piston ring set Ø 78 mm Citroen Traction U23 HY 2x2.5x5 - 4cyl
Segment set Ø 78 mm Citroen Traction 2x2.5x5 - 4cyl
€113.40 TTC
(94,50 € HT)
(94,50 € HT)
Clutch mechanism type 1 Citroen HY
Clutch mechanism reconditioned, in standard exchange. Fitted on Citroen HY, type H, cast iron cylinder headComplete disassembly, micro balling, surfacing and retaring of the pressure plate.(The sending is done after receipt of the used mechanism, ...
€504.00 TTC
(420,00 € HT)
(420,00 € HT)
Ignition harness - 1963 and up - Citroen HY engine H72 or H78 (ID19)
Ignition harness (5 wires) for Citroën HY engine H72 or H78, DS 19 ID 19. Highly recommended with electronic ignition.Wire with red insulation, works with platinum screws or electronic ignition, current manufacture (not from old stocks).
€34.80 TTC
(29,00 € HT)
(29,00 € HT)
Connecting rod bearings (set) 47.75 mm dimension 0.25 - Citroen Traction 11D - HY - U23
Set of 47.75 mm connecting rod bearings - dimension 0.25 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
€102.00 TTC
(85,00 € HT)
(85,00 € HT)
Rod bearings (set) 48 mm STD side - Citroen Traction 11D - HY - U23
Set of 48.00 mm connecting rod bearings - original STD dimension - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
€102.00 TTC
(85,00 € HT)
(85,00 € HT)
Bearing bearings dimension 49.75 mm (0.25) - Citroen Traction HY U23
Bearing bearings dimension 49.75 (0.25) -Citroen:- Traction Perfo and 11D - HY until 1963 ("Traction" type engine)- U23
€477.60 TTC
(398,00 € HT)
(398,00 € HT)
Connecting rod bearings (set) 47.50 mm dimension 0.50 - Citroen Traction 11D - HY -U23
Set of 47.50 mm connecting rod bearings - dimension 0.50 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
€102.00 TTC
(85,00 € HT)
(85,00 € HT)
Air filter cartridge - Citroen HY 1963 and end of series
Size 265 mm x diam 110 mm approximately
€30.00 TTC
(25,00 € HT)
(25,00 € HT)
4 intake valves 42 x 107.7 x 9 mm - Citroen HY engine ID19
4 intake valves 42 x 107.7 x 9 mm - Citroen HY from 1963 and Citroen DS and ID until 1965
€81.64 TTC
(68,03 € HT)
(68,03 € HT)
Echappement sangle support renforcé 50 mm
Sangle de suspension pour échappement, caoutchouc armé. entraxe 52 mm pour vis M8 mm.
€9.03 TTC
(9,03 € HT)
(9,03 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
€195.68 TTC
(163,07 € HT)
(163,07 € HT)
12v to 6v regulator for temperature, pressure, fuel gauge
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
€36.00 TTC
(30,00 € HT)
(30,00 € HT)
Segment set Ø 78 mm Citroen HY 2 x 2.5x4x4 - 4cyl
Segment set Ø 78 mm Citroen Traction 2.5x2.5x4x4 - 4cyl
€162.00 TTC
(135,00 € HT)
(135,00 € HT)
