Exhaust suspension ring 63x96 width 27 mm - Peugeot 203
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
(11,00 € HT)
Insulating tube x4 for spark plug - Citroen HY
(15,00 € HT)
New connecting rod for mounting with bearing - Citroen HY engine ID19
New connecting rod for assembly with bearing - Citroen Traction 11hp and 15hp and HY engine ID 19 current 63 and end of series.Supplied without pad. It is advisable to replace all 4 connecting rods at the same time.
(115,00 € HT)
Spark plug extension x 4 - Citroen HY
Spark plug extension x 4 - Citroen HYGasoline engine from 1963 and end of series
(18,00 € HT)
Connecting rod bearings (set) 47.75 mm dimension 0.25 - Citroen Traction 11D - HY - U23
Set of 47.75 mm connecting rod bearings - dimension 0.25 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
(85,00 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
(163,07 € HT)
Set of 2 multiplier gears "+ 15%" for Citroen HY gearbox
Set of cut-rectified multiplier gears. Allows to lengthen by about 15% all the ratios of the HY gasoline engine gearbox (ONLY on gearboxes equipped with a 21 and 26 tooth set). Concerns the 2 gears at the back of the box.Warning: any change in ...
(1 610,00 € HT)
Calibrouge (Plastigage) mechanical clearance measurement
"Plastigage"The Calibrouge ("plastigage or plastigauge") is a simple and practical tool for measuring the clearances of your bearings. Range of use: operating clearance from 0.025 to 0.175 mm
(22,50 € HT)
Ignition finger igniter Ducellier 65mm
Finger for Ducellier distributor equipped with a 65mm headMounts with Ducellier 65 mm head
(11,25 € HT)
Joint carter huile + demi lune moteur 11D culasse fonte - Citroen U23 Traction HY
(20,00 € HT)
main bearings 53.25mm - over 0.75 - without cheek - Citroen HY
main bearings dimension 0.75 -For HY H72 or H78 engine
(244,00 € HT)
Connecting rod bearings (set) 47.50 mm dimension 0.50 - Citroen Traction 11D - HY -U23
Set of 47.50 mm connecting rod bearings - dimension 0.50 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
(85,00 € HT)