Front brake cylinder Ø 28.5 mm - set of 4 - Simca Ariane
Set of 4 front brake cylinders. - Simca Ariane 4 and Ariane 8 - Simca 1300 until September 1965Includes: one cylinder with left bleeder, one with right bleed and two cylinders without bleed.Liquid entry 3/8Diameter 28.57 mm
(218,00 € HT)

Set of 4 relined rear brake shoes Simca Ariane
Set of 4 relined brake shoes (Ar) for Simca Ariane 4 or Ariane 8 - in standard exchange. Microblasting, varnish, industrial bonding of friction. Strong adhesion. Eliminates the problem of rivets which can damage the drums.Shipping upon receipt of ...
(104,45 € HT)

Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(9,00 € HT)
22mm master cylinder kit Simca Versailles Chambord
Complete overhaul kit for 22 mm master cylinder.
(26,00 € HT)

Flexible rear brake hose 349 mm Simca Versailles Chambord Ariane
Flexible rear brake hose 349 mm long. Male ext 9mm - female int Ø 8.3 mm. Don't forget to replace the copper gasket: click here a> (The vehicle has only 1 rear flexible) - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and ...
(27,00 € HT)
Front brake cylinder rebuild kit Ø 28.5 mm - Ford Vendome - Simca Chambord
Necessary repair for 1 front wheel cylinder.
(20,35 € HT)

Rear brake cylinder rebuild kit 19mm - Simca Chambord
" Complete overhaul kit for a rear wheel cylinder. Diameter: 23.81 mm "
(20,00 € HT)

Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
3/8 - 24 f copper pipe fitting
Rigid brake line nut. 3/8 x 24 threads / inch. Tube Ø 4.75 mm
(6,50 € HT)
Front brake hose 349 mm Simca Versailles Chambord Ariane
Front brake hose 349 mm long. (The vehicle has 2 front hoses) Ø 3/8 For Simca V8, Versailles, Regence, Chambord, Présidence, Trianon, Marly, Ariane 4 and Ariane 8, etc.
(27,00 € HT)
Front brake cylinder D Ø 28.5 mm - with bleeder Simca Ariane
Brake cylinder for front right wheel, equipped with a bleeder - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and Ariane 8 - Simca 1300 until September 1965Diameter 28.57 mm - Liquid inlet 3/8
(56,50 € HT)

Viewed products
Front brake cylinder 28.5mm - Simca 8 - 1200 - Sport
Front brake cylinder. Diam 28.5 mm. Fitting on Simca 8 1200 cm3 and Sport. entry 7 / 16th
(54,50 € HT)

black sheet metal protection seal - 18 ml
(90,00 € HT)
Brake hose 367 mm - front or rear - Simca 1300
Front or rear brake hose length 367 mm.Male ext 9mm - female int Ø 8.3 mmMounts on:- Simca 1300 front or rear- Simca 1500 rear onlyCheck with your model before ordering.
(22,00 € HT)
Rear brake cylinder Ø 23.81 mm - cone protruding - Simca Ariane
Rear wheel cylinder. Left or Right Mount - Simca Beaulieu, Chambord, Présidence, Ariane 4 and Ariane 8.Diameter: 23.81 mm. Version with cone protruding from the bottom of the thread at the liquid inlet. Also available as an incoming cone. See ...
(52,00 € HT)

Transparent flashing light - Citroen HY
Transparent light - without lamp - Citroën HY
(22,50 € HT)
Set of 4 relined rear brake shoes Simca Ariane
Set of 4 relined brake shoes (Ar) for Simca Ariane 4 or Ariane 8 - in standard exchange. Microblasting, varnish, industrial bonding of friction. Strong adhesion. Eliminates the problem of rivets which can damage the drums.Shipping upon receipt of ...
(104,45 € HT)

joint lunette arriere Ford Anglia
(150,00 € HT)
Ignition harness - 1963 and up - Citroen HY engine H72 or H78 (ID19)
Ignition harness (5 wires) for Citroën HY engine H72 or H78, DS 19 ID 19. Highly recommended with electronic ignition.Wire with red insulation, works with platinum screws or electronic ignition, current manufacture (not from old stocks).
(45,00 € HT)