- New
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)
Shipping after receipt of your model.
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
Set of 4 new 35mm front brake shoes. Peugeot 203Friction pads installed using industrial bonding; no more rivets that damage the drums.
Set of 4 front brake shoes - width 52 mm - standard exchange. (Send us your set before shipping the new one). High performance friction, applied by industrial bonding, no more rivets that damage the drums. Pickled and varnished brake shoes.

Adaptateur freinage mâle 7/16 (envion 11mm) femelle 11/16 pour recevoir gros flexible (17mm mâle
Brake line remanufactured on request, only in copper diameter 6.35 mm. Large model, length from 50 cm, max 2m. Provide model (length and 2 original tips)Shipping after receiving your model.
Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone
" Complete master cylinder for Peugeot 203 Piston 1 p or 25.4 mm Outlet 1/2 20 f per inch Inlet 17 mm approximately Center distance 60 mm for M 8 screws "

Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
Adaptateur freinage mâle 7/16 (envion 11mm) femelle 3/8
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
Handbrake cable for left or right rear wheel - Long 154 cm - Saloon 203 C 1954 - 60(2 cables are needed per vehicle)
Brake line remanufactured on demand only in copper diameter 6.35 mm. Small model, length less than 50 cm. Provide model (length and 2 original tips) Shipping after receipt of your model.