Brake line - from 150 to 200 cm
Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.
€69.24 TTC
(57,70 € HT)
(57,70 € HT)
Front wheel brake hose - 380 mm Citroen HY until 06/1963
Brake hose length 380 mm - male end 17 mm - for Front wheel L or R Citroen HY type H, 1948 to June 1963Made in France
€30.00 TTC
(25,00 € HT)
(25,00 € HT)
copy of Brake line - Ø 4.5 mm - 0 to 50 cm
Brake line remanufactured on demand only in copper diameter 4.5 mm.
€62.04 TTC
(51,70 € HT)
(51,70 € HT)
Pipe connector 1/2 20 UNF - tube 6.35 mm - external thread 12.5 mm
Rigid brake line nut. 1 / 2-20 UNF or Ø 12.5 mm - drilling for 6.35 mm tube (1/4 p)
€5.40 TTC
(4,50 € HT)
(4,50 € HT)
Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone
Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone
€18.00 TTC
(15,00 € HT)
(15,00 € HT)
Citroen HY type H brake limiter distributor
Citroen HY type H brake limiter distributor
€258.00 TTC
(215,00 € HT)
(215,00 € HT)
Pipe Ø 8 mm from reservoir to master cylinder - 1 m
Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...
€50.40 TTC
(42,00 € HT)
(42,00 € HT)
Brake pipe - from 300 to 350 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
€90.84 TTC
(75,70 € HT)
(75,70 € HT)
Fuel pump - GUIOT 90 mm diaphragm kit Citroen Traction U23 HY
Replacement diaphragm for GUIOT fuel pump (Citroen Traction U23 HY engine). Ø 90mm. Supplied with membrane and gaskets. (check the type of pump before ordering)
€30.00 TTC
(25,00 € HT)
(25,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
€13.80 TTC
(11,50 € HT)
(11,50 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
€10.80 TTC
(9,00 € HT)
(9,00 € HT)
Rear brake cylinder Ø 28.5 mm Citroen HY
Rear brake cylinder for Citroen HY or type H piston diameter = 28.5 mm. (from 1967, until the end)French made.
€74.40 TTC
(62,00 € HT)
(62,00 € HT)
