
Rear brake hose D 400mm - Citroen HY - from June 1963 to the end
Brake hose REAR RIGHT for Citroen from June 1963 to end: HZ HY HWLong 400 mm
(25,00 € HT)
Rubber teat end for brake reservoir
" Flexible connection for brake reservoir. (100% rubber compatible with lockheed and silicone) Must be fitted with the metal insert to prevent tearing and accidental emptying of the liquid reservoir. "
(9,50 € HT)
Adapter connection 7/16 male - 3/8 female
Adaptateur freinage mâle 7/16 (envion 11mm) femelle 3/8
(19,00 € HT)
Citroen H and HY tandem master cylinder
Tandem master cylinder (dual circuit) 25.4 mm fitting citroen HY from 1975
(369,00 € HT)

Rear wheel brake hose - 380mm Citroen HY until 06/1963
Brake hose length 380 mm - male end 17 mm - for Rear wheel L or R Citroen HY type H, 1948 to June 1963Made in France
(25,00 € HT)
Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone
Adapter fitting 1/2 UNF Male - 1/2 UNF female with internal bicone
(15,00 € HT)
Rear brake hose with double connections on pipe - 320 mm - Citroen HY - after 1970
Brake hose for Citroën HY. Model equipped with fittings allowing connection with rotating nut on rigid pipe on both sides. Often fitted after 1970 - Long 320 mm. Only for synthetic liquid (Dot 3, Dot 4). For use with LHM call us
(27,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Brake line - Ø 4.5 mm - 200 to 250 cm
Brake line remanufactured on demand only in copper diameter 4.5 mm.
(63,70 € HT)
Adapter fitting 3/8 UNF Male - 10x100 female
Adapter fitting 3/8 UNF Male - 10x100 female
(17,00 € HT)
Fuel pump - GUIOT 90 mm diaphragm kit Citroen Traction U23 HY
Replacement diaphragm for GUIOT fuel pump (Citroen Traction U23 HY engine). Ø 90mm. Supplied with membrane and gaskets. (check the type of pump before ordering)
(25,00 € HT)
Viewed products
Set of 8 pistons 66.50 Ford Vedette
Set of 8 pistons - New manufacture, similar to the original model - reduction in piston mass (approximately 255 gr with rings) - molybdenum treatment - cylinder dimension 66.50 mm. Supplied with segments, pins and circlips - The segments supplied ...
(1 290,00 € HT)