Copper gasket 11.50 x 20

Copper gasket 20x11.50 mm thickness 1mm

€1.80 TTC
(1,50 € HT)

Complete master cylinder 25.4 mm - HY Citroen

Complete master cylinder D 25.4 mm for Citroën HY single circuit. For vehicles before 1975.Piston 1 p or 25.4 mm1/2 output 20 f per inchEntry about 17 mm60 mm center distance for M 8 screws

€64.80 TTC
(54,00 € HT)

Copper gasket 12 x 18 mm

Copper gasket 12 x18 x  1.5mm thick

€1.80 TTC
(1,50 € HT)

Adapter fitting 3/8 UNF Male - 10x100 female

Adapter fitting 3/8 UNF Male - 10x100 female

Pipe connection 1/2 20 UNF - 8 mm tube - special jar - 12.5 mm thread ext.

Rigid brake line nut. 1 / 2-20 UNF i.e. Ø 12.5 mm - drilling for 8 mm tube special brake reservoir

Raccord adaptateur 1/2 UNF mâle - 3/8 UNF femelle

Adaptateur freinage  1/2-20 UNF mâle par 3/8 24 filets femelle  

Rear brake hose D 400mm - Citroen HY - from June 1963 to the end

Brake hose REAR RIGHT for Citroen from June 1963 to end: HZ HY HWLong 400 mm

Copper pipe fitting 7/16 - ext thread 11mm

Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm

Fuel pump - GUIOT 90 mm diaphragm kit Citroen Traction U23 HY

Replacement diaphragm for GUIOT fuel pump (Citroen Traction U23 HY engine). Ø 90mm. Supplied with membrane and gaskets. (check the type of pump before ordering)

Dot 4 brake fluid

Dot 4 brake fluid - 500ml can. Non contractual photo

Brake line - from 150 to 200 cm

Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.

Contacteur stop mécanique - Citroen HY

Brake switch - STOP - spring-loaded

Mechanical brake switch. STOP light function. To be fixed on bodywork or chassis.

Brake pipe - from 250 to 300 cm

Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.

Copper gasket 10.5 x 20

Copper gasket 10.5 x 20 thickness 1mm

€1.80 TTC
(1,50 € HT)

Special brake grease tube - Plastilub ATE - 75 ml

Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!