Copper gasket 13.1 x 17

Copper gasket 13.1 x 17 mm thickness 1mm

€1.80 TTC
(1,50 € HT)

Brake line - from 150 to 200 cm

Brake line re-manufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original end pieces)Shipping after receiving your model.

Springs - set of 8 for front brake - Citroen HY - type H

Springs - set of 8 for front brake - Citroen HY - type HSet for 2 front wheels

Fuel pump - GUIOT 90 mm diaphragm kit Citroen Traction U23 HY

Replacement diaphragm for GUIOT fuel pump (Citroen Traction U23 HY engine). Ø 90mm. Supplied with membrane and gaskets. (check the type of pump before ordering)

Male connector 12x100 on 6.35 mm pipe

Male connector 12x100 on 6.35 mm pipe

Brake line - from 100 to 150 cm

" Brake line remanufactured on request, only in copper diameter 6.35 mm. . Provide model (length and 2 original end caps) Shipment after receipt of your model. "

Complete master cylinder 25.4 mm - HY Citroen

Complete master cylinder D 25.4 mm for Citroën HY single circuit. For vehicles before 1975.Piston 1 p or 25.4 mm1/2 output 20 f per inchEntry about 17 mm60 mm center distance for M 8 screws

€64.80 TTC
(54,00 € HT)

Copper seal 10.2 x 13.5

Copper gasket 10.2 x 13.5 mm thickness 1mm

€1.80 TTC
(1,50 € HT)

Pipe Ø 8 mm from reservoir to master cylinder - 1 m

Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...

Citroen HY 22mm rear brake cylinder

Rear brake cylinder for Citroen HY or type H piston diameter = 22 mm. (until 1966)All the brake parts we sell are made in France.

€76.74 TTC
(63,95 € HT)

Ressort frein arrière - Citroen HY - type H

Handbrake cable left or right from 1963 - Citroen HY

Handbrake cable for left or right wheel - 1963 end of series (ID19 engine) - Citroen HYYou need 2 per vehicle (sold individually)

Special brake grease tube - Plastilub ATE - 75 ml

Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!

Rear brake hose G 432mm - Citroen HY - from June 1963 to the end

Brake hose REAR LEFT for Citroen from June 1963 to end: HZ HY HWLong 432 mm

copy of Brake line - Ø 4.5 mm - 0 to 50 cm

Brake line remanufactured on demand only in copper diameter 4.5 mm.

Brake reservoir with rubber

Translucent tank, delivered with bracket; rubber plug and fitting.