Raccord adaptateur 1/2 UNF mâle - 3/8 UNF femelle
Adaptateur freinage 1/2-20 UNF mâle par 3/8 24 filets femelle
(10,50 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(8,85 € HT)
Complete master cylinder 25.4mm - Citroen Traction
" Complete master cylinder D 25.4 mm. For Traction 7.11 and 15 hp. Piston 1 p or 25.4 mm Outlet 1/2 20 f per inch Inlet 17 mm approximately Center distance 60 mm for M 8 screws "
(52,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,20 € HT)
Adapter connection 1/2 UNF female - 3/8 UNF male
Braking adapter 1 / 2-20 UNF female by 3/8 24 male threads
(9,90 € HT)
Adapter connection 7/16 UNF female - 1/2 UNF male
Adapter connection 1/2 UNF male - 7/16 UNF female
(9,96 € HT)
Special brake grease tube - 5g
Tube of special braking grease (5gr), Lockheed DOT and silicone compatible, protects steel cylinder and piston parts, helps them slide, compatible with rubber parts.
(3,89 € HT)
Brake reservoir with nipple + contact
Brake fluid reservoir, translucent plastic.With plug, fixing bracket and electrical contact for minimum liquid level
(39,85 € HT)
Brake reservoir with rubber
Translucent tank, delivered with bracket; rubber plug and fitting.
(31,75 € HT)
Flexible front brake hose 380 mm - Citroen Traction
" Flexible front brake hose length 380 mm. (Attention depending on assembly exists in length 470 mm (available on the Shop) Traction 7.11 and 15 hp - U23 and HY "
(25,00 € HT)
Brake line - from 200 to 250 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(128,00 € HT)
Rubber teat end for brake reservoir
" Flexible connection for brake reservoir. (100% rubber compatible with lockheed and silicone) Must be fitted with the metal insert to prevent tearing and accidental emptying of the liquid reservoir. "
(9,00 € HT)
Pipe connector 1/2 20 UNF - tube 6.35 mm - external thread 12.5 mm
Rigid brake line nut. 1 / 2-20 UNF or Ø 12.5 mm - drilling for 6.35 mm tube (1/4 p)
(4,35 € HT)