Ignition harness - 1963 and up - Citroen HY engine H72 or H78 (ID19)
Ignition harness (5 wires) for Citroën HY engine H72 or H78, DS 19 ID 19. Highly recommended with electronic ignition.Wire with red insulation, works with platinum screws or electronic ignition, current manufacture (not from old stocks).
€54.00 TTC
(45,00 € HT)
(45,00 € HT)
Spark plug extension x 4 - Citroen HY
Spark plug extension x 4 - Citroen HYGasoline engine from 1963 and end of series
€21.60 TTC
(18,00 € HT)
(18,00 € HT)
Clutch mechanism type 2 - fits to clutch disq springless - Citroen HY
Clutch mechanism reconditioned, in standard exchange mounted on HY engine (aluminum cylinder head).Complete disassembly, micro balling, surfacing and retaring of the pressure plate.(The sending is done after receipt of the used mechanism, not ...
€378.00 TTC
(315,00 € HT)
(315,00 € HT)
Clutch mechanism type 1 Citroen HY
Clutch mechanism reconditioned, in standard exchange. Fitted on Citroen HY, type H, cast iron cylinder headComplete disassembly, micro balling, surfacing and retaring of the pressure plate.(The sending is done after receipt of the used mechanism, ...
€600.00 TTC
(500,00 € HT)
(500,00 € HT)
4 exhaust valves 37 x 105.5 x 9 mm - Citroen HY engine ID19
4 exhaust valves 35 x 105.5 x 9 mm - Citroen HY from 1963 and Citroen DS and ID until 1965
€81.64 TTC
(68,03 € HT)
(68,03 € HT)
Fuel gauge - replacement plastic float
White plastic float. Used to replace ring gauge floats.
€15.00 TTC
(12,50 € HT)
(12,50 € HT)
Standard 6V coil ignition
Branded ignition coil guaranteed for use with 6 V platinum-plated igniter (breakers). Impedance respected to prevent the breakers from becoming blue. Also works perfectly with electronic module or integral electronic igniter.
€54.00 TTC
(45,00 € HT)
(45,00 € HT)
Bearings 54.00mm - STD dimension - without cheek - Citroen HY
Bearing bearings dimension 50.00 (STD) -For ID 19 engine and similar engine block
€218.40 TTC
(182,00 € HT)
(182,00 € HT)
Engine paint black RAL 9005 - 500 ml
Black paint - 500 ml jarSuitable for engines, housings, gearboxes, differentials, brake drums and all parts subject to heating in cast iron, steel and light alloys.Direct application on degreased metal (or better, treated with our Phosprim 4090), ...
€40.80 TTC
(34,00 € HT)
(34,00 € HT)
Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
€10.20 TTC
(8,50 € HT)
(8,50 € HT)
Set of 78mm flat piston liners - Citroen HY with Traction engine - Before 1963
Set of 4 liners + 4 complete flat head pistons (segments, clips, pins) - Quality segments.Bore Ø 78 mm - For Citrien HY engine before 1963 (Traction type engine with cast iron cylinder head)total height of jacket 185.50 mm top / base height ...
€444.00 TTC
(370,00 € HT)
(370,00 € HT)
Aviation collex type paste gasket for cylinder head - 117ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
€41.22 TTC
(34,35 € HT)
(34,35 € HT)
Valves x 4 - ADM Ø 37x9x101.6 - Citroen Traction 11 perfo - HY Perfo engine - U23 flat wings
Set of 4 ADM valves Ø 37x9x101.6 - Citroen Traction 11 perfo - HY from 1955 to 63 Perfo engine - U23 flat wings
€149.00 TTC
(124,17 € HT)
(124,17 € HT)
Air filter cartridge - Citroen HY 1963 and end of series
Size 265 mm x diam 110 mm approximately
€30.00 TTC
(25,00 € HT)
(25,00 € HT)
Rod bearings (set) 48 mm STD side - Citroen Traction 11D - HY - U23
Set of 48.00 mm connecting rod bearings - original STD dimension - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
€108.00 TTC
(90,00 € HT)
(90,00 € HT)
