gasket for solex 32 pbic carburetor
2 x paper gaskets for Solex 32 pbi carburetor base.Fixing center distance: 60 mmCentral passage: 32 mmTotal length: 78 mmwidth: 50mm
(3,80 € HT)
Bearing bearings 53.50mm - dimension 0.50 - without cheek - Citroen HY
Bearing bearings dimension 0.50 -For HY H72 or H78 engine
(138,00 € HT)
Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
(8,50 € HT)
Fuel pump - angled outputs - Citroen type Traction - U23 - HY
Fuel pump with primer, for Citroën Traction, delivered with gasket. Can also be mounted on U23 gasoline engine, HY, type H, and HZ equipped with the engine type Traction.
(30,00 € HT)
Ignition coil 6V - High Performance
Bosch, NGK or Béru High Performance type ignition coil, guaranteed for use with:- 6 V platinum-plated screw igniter (breakers),- electronic ignition type 123 ignition,- platinum screw igniter + electronic amplification module
(68,00 € HT)
Piston ring set Ø 78 mm Citroen Traction U23 HY 2.5x2.5x4x4 - 4 cyl
Piston ring set Ø 78 mm Citroen Traction U23 HY 2.5x2.5x4x4 - 4 cyl
(99,00 € HT)
Bearing bearings dimension 49.00 mm (1.00) - Citroen Traction HY U23
Bearing bearings dimension 49.00 (1.00) -Citroen:- Traction Perfo and 11D - HY until 1963 ("Traction" type engine)- U23
(398,00 € HT)
Rod bearings (set) 48 mm STD side - Citroen Traction 11D - HY - U23
Set of 48.00 mm connecting rod bearings - original STD dimension - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
(90,00 € HT)
Fuel pump - 6V or 12V control push button
6 or 12v 10A push button. Can be used to activate an electric fuel pump for a few seconds, for example.
(8,25 € HT)
Ignition set of SEV breakers
" Set of breakers for SEV igniter For Renault Prairie, R2087, Goélette and derivatives "
(18,00 € HT)
Aviation collex type paste gasket for cylinder head - 450ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
(35,00 € HT)
Ignition head Ducellier 65 mm
Head for Ducellier distributor: Interlocking inside the head = 65 mm, outside about 72 mm.To be assembled with breakers 1 237 013 808, and ducellier finger.
(15,00 € HT)
Exhaust suspension ring 63x96 width 27 mm - Peugeot 203
Suspension ring for Peugeot 203 exhaust and othersDimension approximately 63 x 96 x width 27 mm
(11,00 € HT)