Metal body battery switch - safety

Coupe batterie - permet d'isoler électriquement la batterie.

Citroen U23 HY 11D engine kit cast iron cylinder head

Engine seal kit for Citroen U23, HY, equipped with 11D engine (cast iron cylinder head). The cylinder head gasket is slightly different from that of the 11D engine for Traction (reverse water pump). See detail of the cylinder head gasket on the ...

Support de manomètre

Support métalique, laqué noir pour manomètre standard D52 mm. Prêt à fixé.

SEV finger ignition large model

Finger for SEV igniter (large model)

Ring hose Citroën HY

Hose connecting ring with water pump / cylinder head

Jeu palier 0.50 ligne d'arbre - Citroen Traction 15/6

Sealing ring spinnaker crankshaft Citroen HY Nov 58 to the end

Crankshaft oil seal on the distri side for Citroen HY, type H, HWMounts on traction type motor from Nov 58 (aluminum casing) and ID 19 type motor from 63 to end of series.

Carburetor similar to the Solex 32 PBIC type

New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control

Air filter cartridge - Citroen HY 1963 and end of series

Size 265 mm x diam 110 mm approximately

Connecting rod bearings (set) 47.75 mm dimension 0.25 - Citroen Traction 11D - HY - U23

Set of 47.75 mm connecting rod bearings - dimension 0.25 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.

Ignition coil 12v standard

Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)

Set of 4 30mm pellets for cast iron cylinder head - Citroen Traction U23 HY

Set of 4 Ø30mm pellets only for cast iron cylinder head - Citroen Traction U23 HY

Clutch mechanism type 1 Citroen HY

Clutch mechanism reconditioned, in standard exchange. Fitted on Citroen HY, type H, cast iron cylinder headComplete disassembly, micro balling, surfacing and retaring of the pressure plate.(The sending is done after receipt of the used mechanism, ...

€504.00 TTC
(420,00 € HT)

Gasket for radiator cap - Citroen HY before 1964 - Traction

Gasket for radiator cap - Citroen HY before 1964 - TractionØ 60 mm exterior - 39 mm interior - th. 2mm

Exhaust support strap reinforces 90 mm

Suspension strap for exhaust. Robust construction, reinforced rubber, metal eyelets.92 mm center distance for M8 mm screws.

Double pressure gauge holder

Metal support, black lacquered for standard manometer D52 mm. Ready to fix.