
Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
(8,50 € HT)
12v to 6v regulator for temperature, pressure, fuel gauge
This module allows the use of 6V pressure gauges on a 12V vehicle (negative to ground). Mounts on a temperature gauge, pressure, fuel gauge, ...Very practical, it is fixed directly on the supply terminal of the pressure gauge thanks to a hole ...
(30,00 € HT)
Fuel pump - angled outputs - Citroen type Traction - U23 - HY
Fuel pump with primer, for Citroën Traction, delivered with gasket. Can also be mounted on U23 gasoline engine, HY, type H, and HZ equipped with the engine type Traction.
(30,00 € HT)
4 intake valves 42 x 107.7 x 9 mm - Citroen HY engine ID19
4 intake valves 42 x 107.7 x 9 mm - Citroen HY from 1963 and Citroen DS and ID until 1965
(68,03 € HT)
Lower hose WITH heating Citroen HY after 07/63
Lower hose with heating flow after 07/1963
(34,00 € HT)
Electronic ignition amplifier assistance module - 6V negative to earth
Electronic ignition assistance module. Allows more energetic spark plug ignition, improves starting, smoother times, helps reduce fuel consumption and consequently pollution.The breakers (platinum screws) are left in place - the original coil can ...
(79,50 € HT)
Reinforced collar for exhaust - Ø 44-47 mm
Reinforced collar for exhaust - Ø 44-47 mmRobust French manufacturing
(4,83 € HT)
Cable kit with 12V starter relay - Citroen HY
(105,00 € HT)
Battery switch - safety
Battery isolator - used to electrically isolate the battery. To be placed on a terminal of the battery.
(10,00 € HT)
Valve guide Ø 9 X 13.06 X 55 - CITROeN Traction 11 - HY - U23
Valve guide Ø 9 X 13.06 X 55 - CITROËN Traction 11 - HY - U23 -Cast iron material
(47,17 € HT)
Ignition head SEV 58 mm
Head for SEV igniter: Interlocking inside the igniterØ socket 58 mm
(30,00 € HT)
Aviation collex type paste gasket for cylinder head - 450ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
(35,00 € HT)
Sealing plate bearing cap 11CV PERFO - Citroen Traction U23 HY
Sealing plate bearing cap 11CV PERFO - Citroen Traction U23 HY
(11,00 € HT)
Viewed products
Rear brake hose - 315 mm - Simca 1000
Brake hose for Simca 1000 - L 315 mm Ø 3/8
(27,00 € HT)
Front brake hose 381 mm - Peugeot 404 sedan
Flexible 381 mm front404 Sedan Oct 1965 to Oct 67404 Diesel Sedan Oct 1965 to Sep 68
(35,00 € HT)