Set of 8 pistons 67.00 Ford Vedette

Set of 8 pistons - New manufacture, similar to the original model - reduction in piston mass (approx. 255 gr with segments) - molybdenum treatment - cylinder dimension 67.00 mm. Supplied with segments, pins and circlips - The segments supplied ...

Manometer Tachometer - 2 - 4 - 6 - 8 cyl - electric 12V - black background - for negative to mass

Mano "OS" Tachometer 0 to 5000 rpm for 4-cylinder petrol engine. Connects to the "break" terminal on the ignition coil. 52 mm recess on the pressure gauge side. delivered with lighting. for negative to ground

Ford Vedette Stromberg 22.2 Carburetor Kit

Overhaul kit for Stromberg 22.2 (2x30 mm) carburetor. Delivered with complete recovery pump. Fitting on Ford Vedette.

Exhaust manifold paint - 250 ml

€48.00 TTC
(40,00 € HT)

Ford Featured Intake Valve

Ford Vedette intake valve, flared tail, rectified occasion. 33.63 x 110 x 6.86 mm

Ignition coil 12v VALEO

Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)

Head gasket 2 mm solid copper Ford Vedette

Solid copper cylinder head gasket. 2mm thickness. Used with planed cylinder head. Tightening to 5m.kg. Mandatory installation with aerosol sealant, available here a>. Measured cylinder head thickness Head gasket type 37.3 mm ...

160 mm float fuel gauge - 6V

" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "

Electronic flasher unit 6V positive on ground - Ford Vedette

rubber fuel gauge seal - 3-hole

Rubber seal for 3-hole fuel gauge

Water pump repair kit with aluminum impeller - Ford Vedette

Repair kit for water pump for "Y" or "T" pump body - years 1949-54. New axle is 16mm instead of 12 mm. So you need to drill body 16.5 mm. We recommend correcting the seat of the rotating joint at the back of the body.

Echappement joint extremite bloc V8 Ford Vedette et Simca

" Exhaust gasket, engine block outlet, small model placed at the ends. 4 on one engine - Sold individually. "

Ford Vedette exhaust valve

Ford Vedette exhaust valve, flared tail, rectified used.

Exhaust - outlet tube + stainless steel stock - Ford Vedette

" Outlet tube with crosshead (bridge passage) to be connected to the silencer outlet. Ford Vedette 1949 to 1954. All stainless steel. "

€426.00 TTC
(355,00 € HT)

Ford Vedette cylinder head bolt set

Set of 34 hexagon head screws to replace the original studs - 3/8 16f / p unc 2 lengths of screws in the set - Allows easy removal of cylinder heads. Tightening 5 m.kg maximum

Oil pressure contact mano - Ford Vedette 1949 - 54

oil pressure switch for Ford Vedette engine from 1949 to 1954 - Thread M 10x100