modification cylindre avec piston alu creux 14mm
(20,00 € HT)
brake hose P5P5 380 mm - hydrovac 404
(29,50 € HT)
flexible sur mesure type S14 S14 – 500mm
(33,29 € HT)
Rear brake cylinder - VLR DELAHAYE
" Rear brake cylinder. D 1" "(25.4 mm). Mounts on all models. Sold individually (1 cylinder per wheel) "
(43,50 € HT)

2 écarteurs acier (occasion) Ford Vedette
(40,00 € HT)
RIGHT rear brake cylinder 20.6 mm - Renault 4 CV - 02/56 to end
RIGHT rear brake cylinder 20.6 mm - Renault 4 CV - 02/56 to end
(51,00 € HT)

Cylinder - front or rear copper seals kit for one wheel - VLR Delahaye
Set of 2 seals for hollow screw and banjo (for 1 cylinder)
(3,40 € HT)

Custom brake hose D13+7/16e male Long 320mm
Made-to-measure front or rear brake hose. A simple call will allow us to determine your type of hose and its length.Same price as a standard model. Citreon HY, type H, HZ, HW.Image not contractual.
(35,00 € HT)
Front cylinder 31.7 mm - HOTCHKISS ARTOIS 864
" Front brake cylinder. D 1" "1/4 (31.75 mm). Sold individually (1 cylinder per wheel). Entry 7/16 - provide 1 seal 025153 + 0225154 "
(44,50 € HT)

Ecrou
(4,80 € HT)
Adapter fitting 3/8 UNF Male - 10x100 female
Adapter fitting 3/8 UNF Male - 10x100 female
(17,50 € HT)
1/2 female 20 UNF connection on 8 mm tube (metal brake jar)
Metal tank foot nut (female 1/2 and d 8mm)
(9,25 € HT)
Pipe connection 1/2 20 UNF - 8 mm tube - special jar - 12.5 mm thread ext.
Rigid brake line nut. 1 / 2-20 UNF i.e. Ø 12.5 mm - drilling for 8 mm tube special brake reservoir
(5,15 € HT)
Remise en état lot de pièces spécifiques
(70,00 € HT)
Canalisation Ø 6.35 mm bocal vers maitre cylindre - 0.5m - avec 2 raccords 1/2 mâle
Brake line remanufactured upon request, exclusively in 8 mm diameter copper.Photo not contractually binding. Supplied WITHOUT fittings - you can order the one you need from our store (for the master cylinder side). The other end is bare (inlet on ...
(45,00 € HT)
Viewed products
Master cylinder 25.4 mm - VLR DELAHAYE
" Complete master cylinder for Peugeot 203 Piston 1 p or 25.4 mm Outlet 1/2 20 f per inch Inlet 17 mm approximately Center distance 60 mm for M 8 screws "
(54,00 € HT)

Clutch mechanism type 3 - fits to clutch disq using springs - Citroen HY
Clutch mechanism reconditioned, in standard exchange mounted on HY engine (aluminum cylinder head).Complete disassembly, micro balling, surfacing and retaring of the pressure plate.(The sending is done after receipt of the used mechanism, not ...
(315,00 € HT)
