copy of 3-way 3/8 24 f connector

3-way 3/8 connection 24 threads - generally at the outlet of the master cylinder

Cylindre 31.75 - 1/2 piston conique - Peerless 6 cylindres

Copper pipe fitting 7/16 - ext thread 11mm

Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm

Custom brake hose D13+7/16e male Long 320mm

Made-to-measure front or rear brake hose. A simple call will allow us to determine your type of hose and its length.Same price as a standard model. Citreon HY, type H, HZ, HW.Image not contractual.

Brake pipe - from 300 to 350 cm

Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.

2 embouts d'adap+écrou+rondelle+fendue+2 vis creuse+2banjo inclinés bronze+4 joints

Pipe connection 1/2 20 UNF - 8 mm tube - special jar - 12.5 mm thread ext.

Rigid brake line nut. 1 / 2-20 UNF i.e. Ø 12.5 mm - drilling for 8 mm tube special brake reservoir

Copper seal 10.2 x 13.5

Copper gasket 10.2 x 13.5 mm thickness 1mm

€1.80 TTC
(1,50 € HT)

3/8 - 24 f copper pipe fitting

Rigid brake line nut. 3/8 x 24 threads / inch. Tube Ø 4.75 mm

various works

kit de reparation servofrein Hydrovac Ø 185 mm - Peugeot 404, Renault R8, Saviem

Hydrovac Ø 185 mm brake servo repair kit - Supplied with valve and residual valve.Peugeot 404, Renault R8, Saviem.

Hose 7.5x13.5 - brake jar / master cylinder - 1ml - Synthetic liquid DOT 4

Hose sold by the meter for jar connection to master cylinder (7.5 mm plastic nipple connection) - 13.5 mm outsideDoes not withstand pressure. TYPE EPDM + textile reinforcement - intended only for synthetic fluid type DOT 4 - Not suitable for ...

€12.60 TTC
(10,50 € HT)

Dot 4 brake fluid

Dot 4 brake fluid - 500ml can. Non contractual photo

7/16 female connection on 6.35 mm tube

7/16 connection on 6.35 mm tube

Special brake grease tube - Plastilub ATE - 75 ml

Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!

raccord 3 voies 3/8 bicone + vis cresue 10x125 + 1 bouchon 3/8