
Ford Vedette gearbox outlet seal ring
Sealing ring (oil seal) placed at the Ford Vedette gearbox outlet.
(14,17 € HT)
Ford Vedette gearbox primary shaft groove bearing
Bearing 40x80x18 with locking groove, special Ford Vedette gearbox
(45,67 € HT)
Upper and lower adjustment for Ford vedette front hub
Allows adjustment of the camber on the front axle. When these parts are worn, play appears making it impossible to adjust the geometry of the front axle and making the vehicle's driving imprecise.Sold individually (2 per front hub)
(96,00 € HT)
Set of 2 pivot 1953-54 Ford Vedette Comete Vendome
Set of 2 pivots (in standard exchange), ready to install. The set includes 1 pivot G + 1 pivot D, new bronze bushings, treated steel pivot pins, rectified axis line.Mounts on- Ford Vedette 1954- some Vedette 1953Another reference is available for ...
(426,20 € HT)
Drive shaft spacers - Ford Vedette
Drive shaft spider. 2 per tree - Sold individually.
(50,00 € HT)
Rubber bush kit - silentblocs for Ford Vedette front axle
Kit including dust covers and other grease covers to remake the front axle, including those for the stabilizer bar. The set includes:4 x ring (ref Ford 3193)4 x steering ball joint grease cover4 x grease cover on upper triangle axle - chassis ...
(463,50 € HT)
Ford Vedette gearbox support
Support for gearbox cross member. You need 2 per vehicle. Sold individually.
(30,00 € HT)
Ford Vedette rear suspension blade bush
" Silent block to be mounted in the eyelets of the rear suspension blades - 6 pieces per suspension (or 12 on a vehicle) - Sold individually D int = 12 mm D ext = 20.5 mm approximately D ext with collar = 30 mm Long without collar = 22 mm "
(13,50 € HT)
Rear hub oil seal Ford Vedette Vendome Comete
Rear drum sealing ring - (Non contractual photo)
(25,00 € HT)
Front hub kit - Ford Vedette - Vendome
Front wheel hub kit. Includes:- 1 internal conical bearing- 1 external conical bearingThe set is valid for one front wheel.
(108,00 € HT)
Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete
Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete(to be mounted on the left and right side)
(15,33 € HT)
Steering relay - Ford vedette - Vendôme - Comet
Steering relay attached to the passenger side chassis. Remember to replace the tie rod with the 2 rotation nuts to remove wear clearances.
(236,00 € HT)
Ford Vedette stabilizer bar support
Mounting bracket for stabilizer bar. 2 per vehicle - Sold individually.
(26,50 € HT)
Set of 2 Ford Vedette front engine mounts
" Set of 2 front supports for V8 Ford Vedette. Fixing center distance to be slightly modified. "
(33,00 € HT)
Ford Vedette spinnaker seal ring
Sealing ring with steel strapping (metallic spinnaker seal) placed on the Ford Vedette bridge nose.
(26,19 € HT)