Drive shaft spacers - Ford Vedette
Drive shaft spider. 2 per tree - Sold individually.
€60.00 TTC
(50,00 € HT)
(50,00 € HT)
Steering relay - Ford vedette - Vendôme - Comet
Steering relay attached to the passenger side chassis. Remember to replace the tie rod with the 2 rotation nuts to remove wear clearances.
€236.00 TTC
(236,00 € HT)
(236,00 € HT)
Rear hub oil seal Ford Vedette Vendome Comete
Rear drum sealing ring - (Non contractual photo)
€30.00 TTC
(25,00 € HT)
(25,00 € HT)
Ford Vedette gearbox inlet seal ring
Sealing ring (oil seal) placed at the Ford Vedette gearbox outlet.35 x 51
€17.00 TTC
(14,17 € HT)
(14,17 € HT)
Ford Vedette rear suspension blade bush
" Silent block to be mounted in the eyelets of the rear suspension blades - 6 pieces per suspension (or 12 on a vehicle) - Sold individually D int = 12 mm D ext = 20.5 mm approximately D ext with collar = 30 mm Long without collar = 22 mm "
€16.20 TTC
(13,50 € HT)
(13,50 € HT)
Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete
Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete(to be mounted on the left and right side)
€18.40 TTC
(15,33 € HT)
(15,33 € HT)
160 mm float fuel gauge - 6V
" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "
€48.00 TTC
(40,00 € HT)
(40,00 € HT)
Grease cover on lower wishbone chassis side - Ford Vedette
Silent block fitted to the lower wishbone axes - Reference Ford 3194 - 4 per vehicle - Sold individually - (18112)
€21.60 TTC
(18,00 € HT)
(18,00 € HT)
Ford Vedette steering ball joint cover
Rubber protection for steering ball joint - 4 per vehicle - Sold individually
€18.30 TTC
(15,25 € HT)
(15,25 € HT)
Ford Vedette gearbox support
Support for gearbox cross member. You need 2 per vehicle. Sold individually.
€36.00 TTC
(30,00 € HT)
(30,00 € HT)
Front hub kit - Ford Vedette - Vendome
Front wheel hub kit. Includes:- 1 internal conical bearing- 1 external conical bearingThe set is valid for one front wheel.
€129.60 TTC
(108,00 € HT)
(108,00 € HT)
Kit 2 x Ford Vedette pivots
" Ford Vedette front pivot repair kit for all models, Bee, Comet, Monte Carlo, Vendôme. Includes 2 pins and 4 bronze bushings. (for 2 wheels). The 2 axes are in treated steel for a much greater hardness than ordinary commercial products. ...
€202.60 TTC
(202,60 € HT)
(202,60 € HT)
Ford Vedette spinnaker seal ring
Sealing ring with steel strapping (metallic spinnaker seal) placed on the Ford Vedette bridge nose.
€31.43 TTC
(26,19 € HT)
(26,19 € HT)
Steering tie rod with 2 tie nuts - Ford Vedette - Vendôme - Comète
Steering rod connecting the relay on the chassis to the steering box's output rod. Supplied with two connecting nuts.Don't forget to replace the relay on the chassis (passenger side).
€300.00 TTC
(300,00 € HT)
(300,00 € HT)
