Grease cover on upper triangle wheel side - Ford Vedette

Protection mounted on the upper arm on the wheel pivot side - Ford reference - 3075 - 4 per vehicle - Sold individually.

IGOL Rallye Gear axle transmission oil SAE 75 80 90 - GL4

Oil for gearbox and bridge for old mechanics. Type SAE 75 80 90 - GL4. 1L container.(Not suitable for Peugeot type screw axles)

Ford Vedette gearbox inlet seal ring

Sealing ring (oil seal) placed at the Ford Vedette gearbox outlet.35 x 51

Etoquiau - central blade fixing - Ford Vedette Vendome Comete monte Carlo

Grease cover on lower triangle wheel side - Ford Vedette

Rubber ring for Ford Vedette front axle - on lower pivot - 4 per vehicle - Sold individually Ford Ref = 3193

Universal bearing grease

For greasing bearings - Water resistant

Cardan transmission grease - 90g tube

Cardan transmission grease - 90g tube

Kit 2 x Ford Vedette pivots

" Ford Vedette front pivot repair kit for all models, Bee, Comet, Monte Carlo, Vendôme. Includes 2 pins and 4 bronze bushings. (for 2 wheels). The 2 axes are in treated steel for a much greater hardness than ordinary commercial products. ...

Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete

Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete(to be mounted on the left and right side)

Set of 2 pivot 1953-54 Ford Vedette Comete Vendome

Set of 2 pivots (in standard exchange), ready to install. The set includes 1 pivot G + 1 pivot D, new bronze bushings, treated steel pivot pins, rectified axis line.Mounts on- Ford Vedette 1954- some Vedette 1953Another reference is available for ...

Front drum spinnaker Ford Vedette 1949-52

Front drum sealing ring Ford Vedette 1949 to 52 - Delivered individually.(Non contractual photo)

Set of 2 Ford Vedette pivots 1949-52

Set of 2 pivots (in standard exchange), ready to install. The set includes 1 pivot G + 1 pivot D, new bronze bushings, treated steel pivot pins, rectified axis line.Mounts on:- Ford Vedette from 1949 to 52- some Vedette 1953- Comète 13 and 22cv, ...

Steering relay - Ford vedette - Vendôme - Comet

Steering relay attached to the passenger side chassis. Remember to replace the tie rod with the 2 rotation nuts to remove wear clearances.

Ford Vedette stabilizer bar bush

Silent block for Ford Vedette stabilizer bar - 4 per side or 8 for a vehicle - Sold individually.

Ford Vedette rear suspension blade bush

" Silent block to be mounted in the eyelets of the rear suspension blades - 6 pieces per suspension (or 12 on a vehicle) - Sold individually D int = 12 mm D ext = 20.5 mm approximately D ext with collar = 30 mm Long without collar = 22 mm "

Steering tie rod with 2 tie nuts - Ford Vedette - Vendôme - Comète

Steering rod connecting the relay on the chassis to the steering box's output rod. Supplied with two connecting nuts.Don't forget to replace the relay on the chassis (passenger side).