Ring x 2 - gearbox lever or column foot - Ford Vedette and derivatives

Set of 2 repair rings to replace the silent blocks of the gearbox levers or those at the bottom of the column - Ford Vedette and derivatives.Requires 2 sets per vehicle

Rear hub oil seal Ford Vedette Vendome Comete

Rear drum sealing ring -  (Non contractual photo)

Gearbox or axle oil SAE 80-140 - IGOL - 1L

Viscosity index 80 - 140API GL-4(Not suitable for Peugeot type screw axles)

Etoquiau - central blade fixing - Ford Vedette Vendome Comete monte Carlo

Set of 2 pivot 1953-54 Ford Vedette Comete Vendome

Set of 2 pivots (in standard exchange), ready to install. The set includes 1 pivot G + 1 pivot D, new bronze bushings, treated steel pivot pins, rectified axis line.Mounts on- Ford Vedette 1954- some Vedette 1953Another reference is available for ...

Upper and lower adjustment for Ford vedette front hub

Allows adjustment of the camber on the front axle. When these parts are worn, play appears making it impossible to adjust the geometry of the front axle and making the vehicle's driving imprecise.Sold individually (2 per front hub)

Steering relay - Ford vedette - Vendôme - Comet

Steering relay attached to the passenger side chassis. Remember to replace the tie rod with the 2 rotation nuts to remove wear clearances.

Ford Vedette steering ball joint cover

Rubber protection for steering ball joint - 4 per vehicle - Sold individually

Ford Vedette stabilizer bar bush

Silent block for Ford Vedette stabilizer bar - 4 per side or 8 for a vehicle - Sold individually.

Ford Vedette gearbox primary shaft groove bearing

Bearing 40x80x18 with locking groove, special Ford Vedette gearbox

Steering tie rod with 2 tie nuts - Ford Vedette - Vendôme - Comète

Steering rod connecting the relay on the chassis to the steering box's output rod. Supplied with two connecting nuts.Don't forget to replace the relay on the chassis (passenger side).

Universal bearing grease

For greasing bearings - Water resistant

Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete

Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete(to be mounted on the left and right side)

Ford Vedette rear suspension blade bush

" Silent block to be mounted in the eyelets of the rear suspension blades - 6 pieces per suspension (or 12 on a vehicle) - Sold individually D int = 12 mm D ext = 20.5 mm approximately D ext with collar = 30 mm Long without collar = 22 mm "

Ford Vedette gearbox support

Support for gearbox cross member. You need 2 per vehicle. Sold individually.

Front hub kit - Ford Vedette - Vendome

Front wheel hub kit. Includes:- 1 internal conical bearing- 1 external conical bearingThe set is valid for one front wheel.