Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete
Spinnaker ring on 1/2 rear shaft - Ford Vedette - Comete(to be mounted on the left and right side)
€18.40 TTC
(15,33 € HT)
(15,33 € HT)
Ford Vedette gearbox primary shaft groove bearing
Bearing 40x80x18 with locking groove, special Ford Vedette gearbox
€54.80 TTC
(45,67 € HT)
(45,67 € HT)
Tie rod ends - Ford Vedette
Set of steering ball joints for Ford Vedette 1949 to 54, Abeille, Vendôme, Comète, Monte Carlo.Includes:- 1 x long ball joint,- 1 x short ball joint.(the adjusting sleeve is not supplied)
€176.00 TTC
(176,00 € HT)
(176,00 € HT)
Grease cover on lower wishbone chassis side - Ford Vedette
Silent block fitted to the lower wishbone axes - Reference Ford 3194 - 4 per vehicle - Sold individually - (18112)
€21.60 TTC
(18,00 € HT)
(18,00 € HT)
Steering relay - Ford vedette - Vendôme - Comet
Steering relay attached to the passenger side chassis. Remember to replace the tie rod with the 2 rotation nuts to remove wear clearances.
€236.00 TTC
(236,00 € HT)
(236,00 € HT)
Grease cover on lower triangle wheel side - Ford Vedette
Rubber ring for Ford Vedette front axle - on lower pivot - 4 per vehicle - Sold individually Ford Ref = 3193
€19.20 TTC
(16,00 € HT)
(16,00 € HT)
Ford Vedette stabilizer bar bush
Silent block for Ford Vedette stabilizer bar - 4 per side or 8 for a vehicle - Sold individually.
€15.60 TTC
(13,00 € HT)
(13,00 € HT)
Drive shaft spacers - Ford Vedette
Drive shaft spider. 2 per tree - Sold individually.
€60.00 TTC
(50,00 € HT)
(50,00 € HT)
Front drum spinnaker Ford Vedette 1949-52
Front drum sealing ring Ford Vedette 1949 to 52 - Delivered individually.(Non contractual photo)
€23.87 TTC
(19,89 € HT)
(19,89 € HT)
160 mm float fuel gauge - 6V
" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "
€48.00 TTC
(40,00 € HT)
(40,00 € HT)
Ford Vedette rear suspension blade bush
" Silent block to be mounted in the eyelets of the rear suspension blades - 6 pieces per suspension (or 12 on a vehicle) - Sold individually D int = 12 mm D ext = 20.5 mm approximately D ext with collar = 30 mm Long without collar = 22 mm "
€16.20 TTC
(13,50 € HT)
(13,50 € HT)
Kit 2 x Ford Vedette pivots
" Ford Vedette front pivot repair kit for all models, Bee, Comet, Monte Carlo, Vendôme. Includes 2 pins and 4 bronze bushings. (for 2 wheels). The 2 axes are in treated steel for a much greater hardness than ordinary commercial products. ...
€202.60 TTC
(202,60 € HT)
(202,60 € HT)
Pair of Ford Vedette front shocks
Set of 2 front shock absorbers for Ford Vedette all models.Record brand, 100% conforms to the original assembly.Sold in pairs.
€279.00 TTC
(232,50 € HT)
(232,50 € HT)
Ford Vedette gearbox support
Support for gearbox cross member. You need 2 per vehicle. Sold individually.
€36.00 TTC
(30,00 € HT)
(30,00 € HT)
Upper and lower adjustment for Ford vedette front hub
Allows adjustment of the camber on the front axle. When these parts are worn, play appears making it impossible to adjust the geometry of the front axle and making the vehicle's driving imprecise.Sold individually (2 per front hub)
€96.00 TTC
(96,00 € HT)
(96,00 € HT)
