Ford Vedette spinnaker seal ring

Sealing ring with steel strapping (metallic spinnaker seal) placed on the Ford Vedette bridge nose.

Grease cover on upper triangle wheel side - Ford Vedette

Protection mounted on the upper arm on the wheel pivot side - Ford reference - 3075 - 4 per vehicle - Sold individually.

Rubber bush kit - silentblocs for Ford Vedette front axle

Kit including dust covers and other grease covers to remake the front axle, including those for the stabilizer bar. The set includes:4 x ring (ref Ford 3193)4 x steering ball joint grease cover4 x grease cover on upper triangle axle - chassis ...

Front hub kit - Ford Vedette - Vendome

Front wheel hub kit. Includes:- 1 internal conical bearing- 1 external conical bearingThe set is valid for one front wheel.

Etoquiau - central blade fixing - Ford Vedette Vendome Comete monte Carlo

Ring x 2 - gearbox lever or column foot - Ford Vedette and derivatives

Set of 2 repair rings to replace the silent blocks of the gearbox levers or those at the bottom of the column - Ford Vedette and derivatives.Requires 2 sets per vehicle

Upper and lower adjustment for Ford vedette front hub

Allows adjustment of the camber on the front axle. When these parts are worn, play appears making it impossible to adjust the geometry of the front axle and making the vehicle's driving imprecise.Sold individually (2 per front hub)

Tie rod ends - Ford Vedette

Set of steering ball joints for Ford Vedette 1949 to 54, Abeille, Vendôme, Comète, Monte Carlo.Includes:- 1 x long ball joint,- 1 x short ball joint.(the adjusting sleeve is not supplied)

Steering relay - Ford vedette - Vendôme - Comet

Steering relay attached to the passenger side chassis. Remember to replace the tie rod with the 2 rotation nuts to remove wear clearances.

Ford Vedette steering ball joint cover

Rubber protection for steering ball joint - 4 per vehicle - Sold individually

Set of 2 pivot 1953-54 Ford Vedette Comete Vendome

Set of 2 pivots (in standard exchange), ready to install. The set includes 1 pivot G + 1 pivot D, new bronze bushings, treated steel pivot pins, rectified axis line.Mounts on- Ford Vedette 1954- some Vedette 1953Another reference is available for ...

160 mm float fuel gauge - 6V

" Float fuel gauge. Adaptable model. Arm length approx. 160 mm. External diameter of plate 54 mm - fixing center distance 38 mm. Supplied with cork seal. 3-hole fixing. Internal resistance approx. 110 ohms. For 6-volt vehicle only. "

Set of 2 Ford Vedette pivots 1949-52

Set of 2 pivots (in standard exchange), ready to install. The set includes 1 pivot G + 1 pivot D, new bronze bushings, treated steel pivot pins, rectified axis line.Mounts on:- Ford Vedette from 1949 to 52- some Vedette 1953- Comète 13 and 22cv, ...

Steering tie rod with 2 tie nuts - Ford Vedette - Vendôme - Comète

Steering rod connecting the relay on the chassis to the steering box's output rod. Supplied with two connecting nuts.Don't forget to replace the relay on the chassis (passenger side).

Ford Vedette gearbox primary shaft groove bearing

Bearing 40x80x18 with locking groove, special Ford Vedette gearbox

Ford Vedette gearbox outlet seal ring

Sealing ring (oil seal) placed at the Ford Vedette gearbox outlet.