Master cylinder outlet connection with banjo
MASTER CYLINDER OUTLET CONNECTION WITH BANJOBolt M1 / 2 * 20F-F7 / 16 * 20FBanjo D15 F3 / 8 * 24F 84 °
€40.80 TTC
(34,00 € HT)
(34,00 € HT)
Rear brake cylinder L or R (incoming) 23.8 mm - Simca Chambord
Rear wheel cylinder. Left or Right mounting - Simca Beaulieu Chambord Presidence Marly Ariane 4 and Ariane 8. Diameter: 23.81 mm - Version with cone entering the bottom of the thread at the liquid inlet. See detail photo.
€61.50 TTC
(51,25 € HT)
(51,25 € HT)
Brake reservoir - male thread + electrical contact
Brake fluid reservoir, translucent plastic. With cap, and electrical contact for low fluid level
€47.40 TTC
(39,50 € HT)
(39,50 € HT)
Front brake cylinder L Ø 28.5 mm - with bleeder - Simca Chambord
" Left front wheel brake cylinder, equipped with a bleeder - Simca Beaulieu, Chambord, Présidence, Marly 2, Ariane 4 and Ariane 8 - Simca 1300 until sept. 1965 Diameter 28.57 mm "
€67.80 TTC
(56,50 € HT)
(56,50 € HT)
22mm master cylinder kit Simca Versailles Chambord
Complete overhaul kit for 22 mm master cylinder.
€31.20 TTC
(26,00 € HT)
(26,00 € HT)
Rear brake cylinder L or R (outgoing) 23.8 mm - Simca Chambord
" Rear wheel cylinder. Left mount or Right - Simca Beaulieu, Chambord, Présidence, Ariane 4 and Ariane 8. Diameter: 23.81 mm. Version with cone protruding from the bottom of the thread at the liquid inlet. See detail photo. "
€62.40 TTC
(52,00 € HT)
(52,00 € HT)
Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
€6.36 TTC
(5,30 € HT)
(5,30 € HT)
Male thread brake reservoir
Brake fluid reservoir. Supplied with bracket, plug and 3/4 male connector 16 threads / p. External thread diameter = 18.5 mm. Delivered without caliper (fixing by the thread on the master cylinder). Lockeed and silicone compatible
€42.00 TTC
(35,00 € HT)
(35,00 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
€13.80 TTC
(11,50 € HT)
(11,50 € HT)
