
Brake line - from 51 to 99 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Large model, length from 50 cm, max 2m. Provide model (length and 2 original tips)Shipping after receiving your model.
(45,70 € HT)
Adapter fitting 3/8 UNF Male - 10x100 female
Adapter fitting 3/8 UNF Male - 10x100 female
(17,00 € HT)
Cylindre de frein avant SAVIEM SG3
(102,00 € HT)
Brake pipe - from 300 to 350 cm
Brake line remanufactured on request, only in copper diameter 6.35 mm. Provide model (length and 2 original tips)Shipping after receipt of your model.
(75,70 € HT)
Special brake grease tube - Plastilub ATE - 75 ml
Tube of special braking grease (75 ml). ATE's Plastilube is used to lubricate the guide faces on calipers and brake linings and to protect them against corrosion.Note: The friction surfaces of the brake pads must not be coated with ATE Plastilube!
(11,50 € HT)
Master cylinder inside pistons 53 mm - NO brake assist - Renault Saviem Sg2
Single circuit master cylinder fits to SG2 Renault or Saviem. NO break assist. Internal diameter (piston) 28.57 mm bettween fixing holes : 60 mm 2 exits 7/16 mm (mesure prise sur le raccord mâle venant de canalisation = 11.1 mm)
(134,00 € HT)

kit de reparation servofrein Hydrovac Ø 185 mm - Peugeot 404, Renault R8, Saviem
Hydrovac Ø 185 mm brake servo repair kit - Supplied with valve and residual valve.Peugeot 404, Renault R8, Saviem.
(158,33 € HT)
Set of 2 special 5/16 screws / FRONT brake cylinder 34.9 mm - 12.5 mm
Fixing kit for a FRONT brake cylinder 34.9 mm - 12.5 mmAttention only concerns 34.9mm cylinders for 12.5mm connection. The models for 11mm have screws in M8 metric
(6,63 € HT)
Metal insert tip for jar
Metal fitting to be fitted with the brake reservoir rubber to prevent the tearing and accidental draining of the brake fluid reservoir.
(9,00 € HT)
Raccord adaptateur 1/2 UNF mâle - 3/8 UNF femelle
Adaptateur freinage 1/2-20 UNF mâle par 3/8 24 filets femelle
(10,50 € HT)
Copper pipe fitting 7/16 - ext thread 11mm
Rigid brake line nut. 7/16 or about 11 mm measured on the external thread and Ø hole for the tube = 6.35mm
(5,30 € HT)
Pipe connection 1/2 20 UNF - 8 mm tube - special jar - 12.5 mm thread ext.
Rigid brake line nut. 1 / 2-20 UNF i.e. Ø 12.5 mm - drilling for 8 mm tube special brake reservoir
(5,15 € HT)