Stainless steel cylinder head tube Citroen Traction - HY - U23
Water tube for cooling cast iron cylinder head. Citroen Traction, HY, U23 and derivativesStainless steel construction
€25.20 TTC
(21,00 € HT)
(21,00 € HT)
Bearing bearings dimension 49.25 mm (0.75) - Citroen Traction HY U23
Bearing bearings dimension 49.25 (0.75) -Citroen: a- Traction Perfo and 11D - HY until 1963 ("Traction" type engine)- U23
€477.60 TTC
(398,00 € HT)
(398,00 € HT)
Aviation collex type paste gasket for cylinder head - 450ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
€42.00 TTC
(35,00 € HT)
(35,00 € HT)
Connecting rod bearings (set) 47.00 mm dimension 1.00 - Citroen Traction 11D - HY -U23
Conrod bearing set 47.00 mm - dimension 1.00 mm - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
€102.00 TTC
(85,00 € HT)
(85,00 € HT)
Sealing ring spinnaker crankshaft Citroen HY Nov 58 to the end
Crankshaft oil seal on the distri side for Citroen HY, type H, HWMounts on traction type motor from Nov 58 (aluminum casing) and ID 19 type motor from 63 to end of series.
€16.88 TTC
(14,07 € HT)
(14,07 € HT)
piston ring set Ø 78 mm Citroen Traction U23 HY 2x2.5x5 - 4cyl
Segment set Ø 78 mm Citroen Traction 2x2.5x5 - 4cyl
€113.40 TTC
(94,50 € HT)
(94,50 € HT)
Sealing plate bearing cap 11CV PERFO - Citroen Traction U23 HY
Sealing plate bearing cap 11CV PERFO - Citroen Traction U23 HY
€13.20 TTC
(11,00 € HT)
(11,00 € HT)
Pressure hose for igniter Ø 5.5 mm - by the meter
Hose to connect the igniter / carburetor depression 5.5 mm sold by the meter.
€10.20 TTC
(8,50 € HT)
(8,50 € HT)
Ignition silicon harness for Citroen HY or DS Traction U23 HY engine
Ignition harness (5 wires) for Citroën HY or ID - DS engine. Highly recommended with electronic ignition.Wire with red silicone insulator, works with platinum screws or electronic ignition, current manufacture (not from old stocks).Use the 4 ...
€69.95 TTC
(58,29 € HT)
(58,29 € HT)
- New
Fuel gauge - replacement float
Float in synthetic material resistant to current fuels. Used to replace the cork floats on the fuel gauge Length: 1.40" Diameter: 1.14"
€17.72 TTC
(17,72 € HT)
(17,72 € HT)
Fuel gauge - Citroen HY
Fuel gauge for Citroen Type H or HY. Supplied with gasket.
€99.60 TTC
(83,00 € HT)
(83,00 € HT)
Rod bearings (set) 48 mm STD side - Citroen Traction 11D - HY - U23
Set of 48.00 mm connecting rod bearings - original STD dimension - Citroen Traction 11D - HY - U23Mounts on engines equipped with bearing connecting rods.
€102.00 TTC
(85,00 € HT)
(85,00 € HT)
Carburetor similar to the Solex 32 PBIC type
New carburettor similar to the Solex 32 PBIC model with accelerator pump. Vacuum outlet on foot base. Depending on the vehicle model, you will need to reset the configuration with the old starter, jets, cap or cover and throttle control
€195.68 TTC
(163,07 € HT)
(163,07 € HT)
Axle 8.5 mm Ø repair - without butterfly - Solex 32 PBIC or similarsimilar
Shaft dimension repair 8.5 mm without butterfly for repair carburettor Solex 32 PBIC or similarOverall length 91.5 mm
€16.95 TTC
(14,13 € HT)
(14,13 € HT)
Ignition harness - 1963 and up - Citroen HY engine H72 or H78 (ID19)
Ignition harness (5 wires) for Citroën HY engine H72 or H78, DS 19 ID 19. Highly recommended with electronic ignition.Wire with red insulation, works with platinum screws or electronic ignition, current manufacture (not from old stocks).
€34.80 TTC
(29,00 € HT)
(29,00 € HT)
