
Set of Gaskets engine Aquilon - Simca Versailles Chambord
Seal kit produced according to Techni-Tacot requirements. Fit to Simca Versailles, Régence, Trianon, Beaulieu, Chambord, Présidence, Ariane 8 and Marly V8 engines. Contains all the gaskets (2 cylinder head gaskets 1.6 mm thick, water pump, ...
(155,00 € HT)
Battery switch - safety
Battery isolator - used to electrically isolate the battery. To be placed on a terminal of the battery.
(10,00 € HT)
Reinforced collar for exhaust - Ø 44-47 mm
Reinforced collar for exhaust - Ø 44-47 mmRobust French manufacturing
(4,83 € HT)
Aviation collex type paste gasket for cylinder head - 450ml
Sealing paste to be applied on both sides of a cylinder head gasket. Product similar to "Collex". Leave to evaporate for about 30 min at room temperature after application, then fit the gasket - improves the seal - recommended with solid copper ...
(35,00 € HT)
Exhaust - stainless steel Y tube (n ° 1) - Simca Versailles
Stainless steel exhaust - Y connecting the 2 cast iron manifolds to the line.Part n ° 1 on the photo
(364,00 € HT)

Ignition coil 12v VALEO
Ignition coil guaranteed for use with a 12 V platinum screw igniter (breakers). Impedance respected to prevent the breakers from bluing.Works perfectly also with electronic module or integral electronic igniter. (Non contractual photo)
(50,00 € HT)
IGOL Rallye Gear axle transmission oil SAE 75 80 90 - GL4
Oil for gearbox and bridge for old mechanics. Type SAE 75 80 90 - GL4. 1L container.(Not suitable for Peugeot type screw axles)
(15,00 € HT)
Ignition capacitor 6, 12 and 24V
6.12V and 24V compatible ignition capacitor.
(12,00 € HT)
Aerosol gasket for cylinder head
Sealing spray varnish to be sprayed on both sides of a cylinder head gasket. Improves sealing, essential with solid copper gaskets (any thickness)
(35,00 € HT)
Metal body battery switch - safety
Coupe batterie - permet d'isoler électriquement la batterie.
(22,50 € HT)
Head gasket 1.6 mm Simca Versailles Chambord
" 1.6 mm cylinder head gasket for Simca V8 engine" "Aquilon" ". Measured cylinder head thickness Head gasket type 37.3 mm (original) 1.6 mm standard gasket from 37.0 to 37.3 mm 1.6 mm standard gasket from 36.0 to 36.9 ...
(66,50 € HT)
solid copper cylinder head gasket 2 mm Simca Versailles Chambord
Solid copper cylinder head gasket. Thickness 2 mm. Used with planed cylinder head. For V8 Simca Trianon, Versailles, Régence, Beaulieu, Chambord, Présidence, Marly 1 and 2, Ariane 8. Also exists in 3mm version (available on the shop) Tightening ...
(160,40 € HT)
Pinion oil pump mounted on axis - Simca Versailles Chambord
Replacement pinion for oil pump - Delivered riveted with new axle - V8 Simca Versailles, Chambord, etc. - Advantageously replaces the celoron one that has become fragile over time.Attention for Ford Vedette V8 12cv 2150 cm3, choose the reference ...
(270,20 € HT)

Cross shaft transmission Simca Versailles Chambord
Transmission shaft crosspiece Simca Trianon, Versailles, Marly, Beaulieu, Chambord, Presidence.23.8 mm x 61.3 mm - assembly with external circlips (supplied with each spider). Check your dimensions precisely because other models have been fitted. ...
(65,00 € HT)
Central intake gasket Ford Vedette Simca
Central gasket intake housing for Vedette Ford and Simca.
(50,00 € HT)
Viewed products
7/16 banjo fitting + 7/16 hollow screw + seals
7/16 banjo fitting + 7/16 hollow screw + sealsDiameter male thread of the screw 11 mm
(27,35 € HT)
Exhaust Presidence - n3 - oval stainless steel silencer - Simca Presidence
Stainless steel silencer exhaust for V8 Simca Aquilon
(484,00 € HT)

Ring x 2 - gearbox lever or column foot - Simca Versailles Chambord
Set of 2 repair rings to replace the silent blocks of the gearbox levers or those at the bottom of the column - Simca Versailles Chambord.Requires 2 sets per vehicle
(32,00 € HT)
Water pump - the seal - Citroën Traction
Gasket for water pump - Impeller Ø 80mm - Citroen Traction
(10,00 € HT)